Hi
We are developing software for the nRF51 with Keil under VirtualBox. Previously we used the PCA10000 dongle with the Master Emulator and MCP without issue. Now, with...
We are using nRF51822 for our products.
We want to know the min value of "Receiver sensitivity" when we use this chip for BLE.
The Datasheet says "Receiver sensitivity...
Dear
The BLE Multi-link example (ble_app_multilink_central and ble_app_multilink_peripheral)
shows how one central device can connect to multiple peripheral devices. ...
In the MCP app, if I have the following service data for an Eddystone beacon:
0x10, // Eddystone-URL type
0x00, // TX power in dBm. This is a signed integer so 0xEE ...
I have the nRF Control Panel Android application. It works fine with several BLE devices, but specifically for the Fitbit Flex, it fails to connect.
I know Fitbit wristbandes...
Hi,
The situation:
I was able to successfully receive known packets from a device running gzp_device_dynamic_pairing, from, the host running the gzp_host_dynamic_pairing...
Hi everyone
nrf51822,softdevice s130 2.0.0
now i used softdevice s130 establish two connection as a central with two s110 peripheral device,at the same time i establish...
Hi
I saw the Central and Peripheral example code has peer_manager in sdk 12.2 and BONDING_ENABLE in sdk10.
What are they does and where has document I can read.
If I...
From the Nordic errata [141] on NFCT not stopping HFO when going from activated state to sense state:
Workaround:
Power cycle the NFCT using the POWER register, then issue...
Hello.
EDIT: When I connect to nRF52832, Windows are not creating bluetooth serial com port. And Bluetoth Services are not getting.
How Can I do this??
Thanks.
Hi.
Is it possible for the NRF52840 to act as a USB host? or is it "only" a USB slave?
It would be awesome if we could connect a usb peripheral directly to the NRF52840...
I'm confused.
in other platform, i know flash stard and end adress ,alse page size ,i can read and write data directly.
But use pstorage mode as follows :
pstorage_init...
Hello,
I want to bring some data by UUID.
I know the ble_nus_init() can set UUID and I know it was set by sd_ble_uuid_vs_add().
But this way only change the UUID while...
Hello.
I loaded Soft Device and UART example on the board. Then I connected Nordic_UART through by Bluetooth.
And I want to add a virtual COM PORT on Win10. I entered...
I want to connect the nrf52 board to my nanoPI via cables/connectors, making a serial communication,
is there an example/tutorial for that?
It's worth mentioning that...
Hi,
Newbie question... I have latest SDK v11.0 and have built the ble_app_uart example (installing the s130 softdevice and app to my nrf51822. I can then power the nrf51822...
hello,
I need to calculate the battery life of cr1632. For the calculation I need to know what is:
-Average Current consumption of device? (nrf51822 Bluetooth smart...
