Hi Guys,
I have a MCU RTOS project. in Hardware board, builtin Nodic BLE chip over UART,RTOS BLE stack works fine.
We also have a MCU RTOS Emulator based on Qemu,we...
Hello,
I would like to have more info about canceling the pairing request on iPhone (thru the popup that asks if you want to pair with the device which is managed by iOS...
Hello everyone, I'm severely struggling to perform a simple task. I must be missing a very simple answer and, I hope with your help that I resolve the issue.
I am trying...
if the issue can be worked ,how to do that with android source code? the 2 ble pure devices (not android phone) connect with a ble android phone.
please check below, the...
Softdevice Version： 8.0.0
SDK： 9.0.0 IC：
NRF51822 Rev 3
service： NUS ANCS
When the application is not downloaded, the bootloader is working.
After serial bootloader...
We're looking for a few (2-3) savvy OS X users who might be interested in trying out Xcode to natively develop code for the nRF51/52 BLE SDK's. This build method does NOT...
Hi, I use PCA10040 v1.1 and SDK12.1. My desktop environment is Windows 7 64bit.
As far as I know, the J-Link Edu cannot be used for commercial usage.
I so bought...
Hi there,
We've had our own custom controller made, based on nRF52 (Rigado BMD-300 module).
In the last half of January we'll have a baseline firmware working, but we...
Hi, sending a data packet, then sleeping (memory retention mode), then sending another identical packet causes the receiver to send back an ACK for the first and trigger NRF_ISR...
Was sd_ble_gatts_value_get changed from s 110 to s 132?
Please tell me how it changed.
sd_ble_gatts_value_get(uint16_t conn_handle, uint16_t handle, ble_gatts_value_t...
Hi team,
I have nRF51822 DK SMA connector module(PCA10005) and j-link lite cortexm-9 JTAG/SWD emulator.can u please tell which sdk version are used for this modules.is...
hello
i am using redbear lab's ble nano with nrf nrf51822 chipset in it. now i need to permanently store some data like sensor values and mac address of central devices...
I'm not able to find an older legacy version of Softdevice S110, specifically 7.2.0.
In the SDK Version 7.2.0 obtained from:
developer.nordicsemi.com/.../
there is...
Hello
I want to establish the connection between nrf51822(base station) and:
the second nrf51822(transceiver)
android smartphone(transceiver)
It has to be possible...
Could someone offer some guidance in how it is possible to keep the radio within IDLE mode between transmissions when operating in ESB mode? I have a sequence of transmissions...
Hi
I'm doing some S/W based on nRF51822_xxAC. I want to split RAM into 2 regions, as following:
+-------------+ 0x20008000
|__ __ _ __ |
|APP ZONE2 |
+-------...
hello, I'm trying to read the status register but all I am receiving is 1111 1111, I tried to change the code to read RX_ADDR_P0, but I also receive 1111 1111. can you tell...
