Hi,
I'm using redbearlab's nrf51822 board. It is a arduino compatible board and hence it is using 0,1 (mapped to 9 and 11 for nrf51822). How do I make printf print to this...
An external PA/LNA is used to extend range of nRF51822, and S110 is used for BLE, How to switch between PA and LNA? and how to disable PA/LNA when there isn't transceiving...
Hi...
Can anybody help me to run ble_peripheral example (ble_app_hrs for S130). I have build and load the code successfully but cant see the advertisement. But while debugging...
I am working with the nRF8001, and I'd like to create a services.h file that will let me broadcast battery level and as well as allow temperature to be read by a peer.
...
Hi We have an application where we what to read i2c sensor data over the air to an iPhone. We've taken ble_app_uart_S130 project and grafted in some twi_hardware code. There...
I am interested in the S130 ability to hold 3 central -> peripheral links over BLE, and am looking for some evidence that this has been accomplished with extremely low-power...
I'm trying to implement channel scanning in our nrf24lu1p based USB dongle.
I'm following the specs and basically loop though each channel ;
loop
stop listening
set...
In SDK 11 description od DTM "vendor specific" settings, there is a lot of inconsistency in parameters names/numbers - could anyone help me understand this part?
As for...
Hi,
Everyone,
I have firmware working with our custom pcbs.
It works fine with new 3.3v battery.
But somehow it does not advertise anything with used battery having...
I have a digital microphone chip, it has the CLK, DATA, LR_SEL three pins, now I will pick up the three pin nrf5283 three pin is as follows: CLK connectionI2S_CONFIG_SCK_PIN...
I guess we need some help with definitions. Basically, we'd like to read data from an I2C line. Should be as simple as "set to input" and "read the pin". However...
In...
Using nRF5 SDK v11.0.0, I am working on bringing up new hardware based on the nRF52. I started with code that works on the PCA10040 development board in which we connected...
I need to calculate radio on time in IoT SDK but IoT softdevice don't provide ble_radio_notification (in sdk components) and nvic functions (don't have nrf_nvic.h in softdavice...
My scenario is I have an android device and 100+ advertising nrf52 devices. Is it possible android to receive/scan advertising packets (small) from 100+ devices which mean...
error occurs in nrf_delay.c of nrf52832
Because there are ASM in nrf_delay.h
nrf_delay.c:
#include <stdio.h>
#include "compiler_abstraction.h"
#include "nrf.h"
...
Hello,
I cannot find an example in the current SDK on how to use APP_UART. I do not want to use app_uart_fifo because it has quite some overhead that I do not need. All...
I am using nRF5_SDK_11.0.0_89a8197 to test esb maximum throughput.
in the macro definition of NRF_ESB_CREATE_PAYLOAD,
#define NRF_ESB_CREATE_PAYLOAD(_pipe, ...)
...
On the nRF51, there are 5 OVERRIDE registers (0-4) in the radio module.
What do those registers do and when should they be used? The FRM was not clear about them.
From what I can see the scenario where you have a serialized app running from a separate CPU and how to do firmware update on that is not discussed anywhere on the Nordic...
