Hi to all Nordic product lovers,
This is not a question but rather an announcement of a new nRF52840 based finger tip size module 14 x 9 x 1.6mm launched at CrowdSupply...
Hi,
I have a SPI slave device which outputs 8-bit registers that I have to assemble. For example, I receive two 8-bit registers, a high and a low register, which I have...
I have a PCA10059 dongle. I have inadvertently configured pin P0.25 as the sleep debug pin and I use active state 0 as I am using off board LEDs with reverse logic. This means...
If you're working on a product that requires you to show and translate GATT Attribute (Service, Characteristic and/or Descriptor) UUIDs to Strings to the user, it's likely...
Hello,
We have been trying the sendNotification call and after getting a success log we are not able to send a second notification. I'll copy the snippet of code that we...
I have a firmware developed on the nrf52840 development board. When porting it to nrf9160, a lot of errors were reported. How can I use the LOG output function on nrf9160...
Hello, I am working on NRF52 DK,SDK12.1.0.
When I am trying to make board into sleep mode with sleep_mode_enter(I have get sd_power_system_off),I found that RAM/UART is still...
Hi,
We designed the circuit followed the reference circuit(QFN48), and all the value of power capacities are also followed the reference circuit. But we failed in the 8kv...
Hi, I'd like to use nrf51 dongle to scan for ant/ant+ communication, but I can't understand how to do that... it doesn't work with antware sw and I don't know how to use it...
Hi,
I use NRF51822 to design a ble product,my client require that when in the front of the ble device the app can connect the ble device,and can't connect in the back of...
My Issue,
I need to be able to set radio RCV/TX signals to a specific distance. I would like to control this
through the firmware. Do you have any recommendations or examples...
Hello,
I am using Keil Lite edition and I'm receiving a linker error from exceeding the code limits in Keil. My code is 37336 bytes and apparently cannot exceed 32000 bytes...
Hi,
I'm currently working on a BLE device which works his whole lifetime on one battery. This means we have to save as much energy as possible. This is why we set our advertisement...
Hi all,
Our company is in the process of certifying a device. This device is using a nrf52832 with radio.
We had no problem to comply with the ETSI standard, but things...
I am trying to set up a custom Advertisement in nRF-Connect for Windows, using an nRF52 DK (PCA10040)
In Advertising Setup, I remove the existing "Complete local lame"...
Hi
I am looking for some example code that shows best how to talk to a servo.. If there isn't any, any ideas which example project comes the closest ?
Thanks
J
Hi,
I was reading datasheet of nRF52832, but i didn't see USB topic in that.
But i checked the SDK which has USB example for HID_keyboard and mouse?
Is that Means we are...
I am trying to run the ble-characteristics tutorial code on a custom nRF52832 board ( MetaMotionR ). The blinky example worked just fine after creating a custom_board.h file...
Hi, I have a need to connect to a peripheral device from and nRF52 with a Bonded connection.
My device handles bonding when it is a peripheral, but what is needed to enable...
