Hi.
I am using the NRF52 Development board, on Keil uVision, to implement a C program that uses Dynamic Structs. The Structs re-size themselves ( by increasing their capacity...
Hello,
I have an NRF51822 (redbealab ble nano) that I would like to use to count pulses in very low power mode.
Pulses are asynchronous
The rate of pulses can...
Hi
I'm attempting to read a PT-100 sensor value that is part of a voltage divider using a nRF52.
Both the reference resistor and the PT-100 is sampled while the voltage...
Hi
I have been searching the forums, but were not able to find an answer to my question.
I'm trying to sample 4 analog inputs on the nRF51-DK using the ADC hal. (SDK10...
Hi
I have been trying to get two NRF24L01 chips communicate with each other since a week now, without much success. All what I can find on the net is Arduino examples using...
Hi
I have done several projects with the nRF905. I know the device quite well. Normally I use the CD, AM and DR interrupt pins to determine the status of the device, my current...
i made this project to try to create RSC service on arduino
developer.bluetooth.org/.../runningspeedandcadence.zip
unfortunately the server starts but i'm not able to...
Good day All,
We are in the process off procuring a project using nRF52, and I need to find out some important things. Are there any costs in using any of the libraries...
I am using nrf52840 module(peripheral) for transmitting 10samples/10ms and central device as the same nrf52840 for receiving the samples. Although I receive the packets, there...
Hello,
I'm working on an application in which I have to dynamically switch between a TWI master peripheral and SPI master peripheral that use the same peripheral ID (our...
I have an NRF24LE1 transmitter using ESB. It is sending a static payload of 10 bytes every sec.
The other configurations on the transmitter are: RF channel:2, CRC: 1 byte...
Hi,
i'm wondering if there is any IC (for example nRF52832) that can reach a range up to 155 meters available within the Nordic semiconductor catalog ?
i know that the...
In nRF5 SDK 12.1.0 a bug was fixed in nrf_drv_wdt_init(). Watchdog timeout could not be larger than 131 seconds because of (x * 32768) multiplication before. This bug is again...
In the spec it says that the typical ramp up time is 140us (or 40us in fast mode). But there is no details on maximum or minimum. What is the true tolerance on this value...
We are building a simple project, let 51822 connect the mobile, once per second. We found that the Tx power of 51822 is getting weaker and weaker (view the voltage over a...
I have a nrf51 dongle and would like to use PWM on 3 pins.
Managed to get it working on pins 15 and 16, but somehow pins from 17 to 20 just don't work.
For example: I set...
Hi,
I have two nrf52840 boards and I am using the ble_app_att_mtu_throughput test app. The tests seem to be working OK, but I am not getting the throughput I was expecting...
When performing flash operations, i.e. via FDS or FSTORAGE, etc. - will GPIOTE events be captured and 'queued' until the CPU is no longer halted?
Said another way:
Can...
Hi ,all
I have a problem in my project .I want to use gzp preload ack feature .When the host receives datas ,I would use this function "void gzp_preload_ack(uint8_t* src...
Hi,
I've asked a few questions previously regarding programming of the nRF24L01/+ for simple data interchange between two devices, and my questions were answered -- many...
