Hi, is there an available developer in my tri-state area of Minnesota, N. Dakota, or S. Dakota? Please call me if you are available for a project for hire. The developer should...
I'm trying to design a very low power sensor that takes readings using ADC and SPI 200 times a second. I'm a bit worried by the current EasyDMA uses (1.1mA). As far as I can...
Hi, I am working on a project where I want to make one nrf51288 chip as central hub and connect that to a android phone and other salve nrf51288 .
idea similar to this: ...
Hi,
I have a code programming the nRF51422 development board to write to a Sharp Memory 96x96 pixel LCD screen using SPI.
Currently the code writes two numbers and a...
I've modified the ble_app_uart example by adding GPIOTE so that the transmitter sends a character to the receiver when a GPIO pin is toggled. This part is working well.
...
Hi,
I am working on my hardware product having nRF-51422 chipset. I just came to know from forum post that
nRF-52 chips will get arduino IDE support as standalone. I want...
Hi, I've read through partially of the "getting started" docs, and I'm still having questions about these issues:
Will there be one dedicated provisioner interfacing...
I was writing 3 character to ble device .but I got below error and ble device got disconnected. LED lights got off...
[CoreBluetooth] API MISUSE: <CBPeripheral: 0x1572b660...
Hi, when doing wired uart-BLE combination and increasing the traffic in the uart comms and BLE comms, at some unpredictable stage, the program flow goes to 0xFFFFFFFE. Any...
Hello,
I am trying to run the ble_app_uart_c example that is part of the nRF5_SDK_13.1.0_7ca7556 on a custom board with nRF52832 using IAR. Hardware seems healthy, I succeeded...
Hi all,
Could you please point me at the tutorial I missed... I am looking to adapt the title project to a custom project. I've run the sample and it advertises and shows...
Hi all
we are working on nrf52832 for our project.
not sure if there is guidelines for pcb antenna.
like limit on number of devices or any other certification we need...
Hi,
I'm using a nrf51 custom board (IC no. N51822QFAAH0) with Softdevice S130 v2.0.0 and SDK_11.
After connecting it with nrf Connect Android App, the device gets disconnected...
Hi:
I'm running S132 SoftDevice for the nRF52832 and am interested in configuring the nRF52832 (slave) to achieve connection intervals from 2 to 16 secs.
Thanks,
JP
On a custom board with an nRF52832 communicating over UART with another microcontroller with no flow control capability.
SDK 13.0.0-1.alpha with an S132SD.
I have some...
Hello everyone,
Thanks in advance for your patience in reading this long message.
I have been having problems with UART over USB on PCA10040 boards for almost four months...
In order to learn how to use the RTC0 to handle an event every second, I am debugging the rtc SDK example.
Expectation : The rtc example sets the time to check the counter...
I need to make sure that the receiver is active in an NRF52832 that I don't have good ability to do DTM commands on; there's a host processor that can do some DTM commands...
For me the sample can be compiled but does not work with PC. SDK is 13.1. OS is W10. Serial port is installed automatically by using W10 standard driver (usbser.inf). There...
