Hello,
I would like to do an communication between Arduino and Android platform.
In my case, Android will be master.
But I want also test between 2 Arduino with an Bluetooth...
Hello,
I would like to develop a custom key sharing algorithm for nRF8001 chips. As far as I have understood the only way to use full 128-bit temporary key (TK) is OOB...
i am useing nRF51822 pairing with nRF24lu1 over GZLL protocol now,
is there someone have the experience on how to config the parameter of GZP_TX_RX_TRANS_DELAY in function...
I have a peripheral running the S110 stack, which presents a characteristic to which I want the central (running S120) to be able to do a long write. What I've been trying...
Hi all,
I have been trying to combine the UART and hID Keyboard examples into a single application.
I want to use the HID part to send specific keystrokes using buttons...
Hi, I'm new to BLE and just started feasibility testing, using RF8001, on a small device with no IO. The device will have a unique code set at factory, and printed on label...
Hello, I am working on NRF52 DK,SDK12.1.0.
When I am trying to make board into sleep mode with sleep_mode_enter(I have get sd_power_system_off),I found that RAM/UART is still...
Hi,
We designed the circuit followed the reference circuit(QFN48), and all the value of power capacities are also followed the reference circuit. But we failed in the 8kv...
Hi, I'd like to use nrf51 dongle to scan for ant/ant+ communication, but I can't understand how to do that... it doesn't work with antware sw and I don't know how to use it...
Hi,
I use NRF51822 to design a ble product,my client require that when in the front of the ble device the app can connect the ble device,and can't connect in the back of...
My Issue,
I need to be able to set radio RCV/TX signals to a specific distance. I would like to control this
through the firmware. Do you have any recommendations or examples...
Hello,
I am using Keil Lite edition and I'm receiving a linker error from exceeding the code limits in Keil. My code is 37336 bytes and apparently cannot exceed 32000 bytes...
Hi,
I'm currently working on a BLE device which works his whole lifetime on one battery. This means we have to save as much energy as possible. This is why we set our advertisement...
Hi all,
Our company is in the process of certifying a device. This device is using a nrf52832 with radio.
We had no problem to comply with the ETSI standard, but things...
I am trying to set up a custom Advertisement in nRF-Connect for Windows, using an nRF52 DK (PCA10040)
In Advertising Setup, I remove the existing "Complete local lame"...
Hi
I am looking for some example code that shows best how to talk to a servo.. If there isn't any, any ideas which example project comes the closest ?
Thanks
J
Hi,
I was reading datasheet of nRF52832, but i didn't see USB topic in that.
But i checked the SDK which has USB example for HID_keyboard and mouse?
Is that Means we are...
I am trying to run the ble-characteristics tutorial code on a custom nRF52832 board ( MetaMotionR ). The blinky example worked just fine after creating a custom_board.h file...
