Suppose a nRF9E5 transmitter is set for continuous transmission on a channel.
A nRF9E5 receiver listening on that channel:
finds carrier and sets CD
finds address...
I will be deploying my nRF51822-powered devices into the field and the end user will not be able to have any physical access to, for example, power cycle the board. I need...
Hi,
We are using the ble_app_uart example in evaluation board to read data from some sensors and send it to the nRF UART V2.0 in Android 4.4. Every 20 ms I am trying to...
I am try this at nrf51_sdk_v6_0_0_43681\nrf51822\Board\nrf6310\s110\ble_app_hids_keyboard
Firt I connect to Android device and keep one whitelist.pp_addrs and one whitelist...
Hi,
Parameter uint8_t ble_gap_scan_params_t::filter is present in the documentation, but not implemented.
Checked for SDK 5.2.0 and 6.0.0.
devzone.nordicsemi.com...
After I get a Disconnected() event, I want to start scanning again, therefore try to call StartDeviceDiscovery() again.
IsDeviceDiscoveryOngoing was checked before.
The...
Since the SoftDevice uses Timer0, am I correct in assuming that the maximum number of PWM channels for nRF51-DK with SoftDevice running is 4? (Two each on Timer1 and Timer2...
Hi Expert,
At my nRF51 platform, I opened two GPIOTE users one of which is used to handle an external sensor interrupt. After invoking app_gpiote_user_register(&sensor_gpiote_user_id...
I am seeing some very strange behavior when using an ANT channel with the sd_ant_acknowledge_message_tx call to guarantee message deliveries between a master and slave.
...
hello I am using nRF51822 microcontroller and KIELuvision5 for programming, I am new to this platform kindly need your help, I was compiling the basic code it toggles an LED...
I tried to follow some tutorials on this site to build the samples for the beacon modules using gcc.
I am seeing this error:
Compiling file: bootloader_util_arm.c
...
I download my elf file using SEGGER Jlink via Eclipse. The instruction pointer gets positioned on the Reset_Handler. But when I try to run the code after that, I get a SIGTRAP...
HI:
I try use pstorage_raw_mode to store data. According to the document description,first steps:
ble_stack_init() and scheduler_init(). Then, in turn, calls the function...
Hello,
I need a FIFO buffer for at least 20 arrays with 8 int32 in each... for use in an algorithm.. is there a more elegant way than just copying them all around each...
I'm using the mbed platform and have been battling hard faults as I try to find the best way to write with high frequency to SPI to update a series of LEDs while still allowing...
I'm migrating an old (but working) app from the S110 5.2.1 (SDK 4.X) to the latest SDK9/S110 8.0. I've read the migration doc, and I'm following the examples carefully (specifically...
Hi,
I downloaded latest version of SDK and all examples resented there are for nrf51422.
Can I use those examples for nrf51822?
I'm using ukeil and I can only select nrf51422...
Our chip seems to be running at ~500uA and I'm trying to narrow it down.
I'm doing periodic battery level checks on a timer using the ADC HAL. So at init I call nrf_adc_configure...
