Hello Nordic Community,
I need to know how to import my PCB design from Eagle to CST Studio to simulate it and I need to know if the simulation step will be useful to enhance...
Hi.
I'm trying to get Apple notifications to nrf52. And specifically to listen both regular ANS (for android) and ANCS (for iOS) events depending what sort of phone is...
I am trying to find out the part number of the antenna (I assume it is a PCB antenna) used in the nRF51 DK ( www.nordicsemi.com/.../nRF51-DK) . I found a lot of similar questions...
Hi.
I am using the NRF52 Development board, on Keil uVision, to implement a C program that uses Dynamic Structs. The Structs re-size themselves ( by increasing their capacity...
Hello,
I have an NRF51822 (redbealab ble nano) that I would like to use to count pulses in very low power mode.
Pulses are asynchronous
The rate of pulses can...
Hi
I'm attempting to read a PT-100 sensor value that is part of a voltage divider using a nRF52.
Both the reference resistor and the PT-100 is sampled while the voltage...
Hi
I have been searching the forums, but were not able to find an answer to my question.
I'm trying to sample 4 analog inputs on the nRF51-DK using the ADC hal. (SDK10...
Hello. I am currently making a data transmission program with BLE. We will create our own custom service and send it in “Notify” format. I want to send 2D array data. The...
Hi
I was trying to build Beacon scanner application .using nrf52 Dongle as a beacon and and nrf52840 DK as a scanner to scan the beacons Kindly please guide me as im new...
We ared esigning a new board with nRF9160 and nRF52811, We want to be able to do FOTA (modem- and app) for the 9160 via the 52811. Are there any special considerations we...
Hello, I am having problems getting the TWI to work. The NRF52810 needs the TWI to communicate with a EEPROM module.
Thus far ive set:
Then I try to do the TWI Scanner...
Hi,
I would like to connect the nRF52840 JTAG to a debug probe in order to debug and program it.
Can I use any debug probe or a specific one is mandatory?
Thanks...
Hi,
i am working on sdk14.2 in SEGGER EMBEDDED STUDIO, i am trying add some file to ble_app_blinky_pca10040_s132 example at the time of compilation i am getting linking...
I have run into a problem compiling with ARM Compiler 6 version.
In this case I cannot figure out the problem.
Seems the only file causeing problems (after fixing a few...
Hi
I am using SDK V. 15.3.0 and Softdevice S132 6.1.1 on a nRF52832. I am developing two devices, one of with is battery powered and one that is connected to a serial interface...
Aside from the connection interval, I'd like to know if the 2Mhz phy is enable along with Data Packet Length Extension and Connection Event Length Extension.
Is there...
The modem_info module in nRF Connect SDK returns various modem parameters to the application. The function "modem_info_params_get" fails to update the following paramters...
We are running an application in dual mode (central + peripheral) where we relay the data from the peripherals up to the top central. Is it possible to control the priorities...
