Hello,
I would like to do an communication between Arduino and Android platform.
In my case, Android will be master.
But I want also test between 2 Arduino with an Bluetooth...
Hello,
I would like to develop a custom key sharing algorithm for nRF8001 chips. As far as I have understood the only way to use full 128-bit temporary key (TK) is OOB...
i am useing nRF51822 pairing with nRF24lu1 over GZLL protocol now,
is there someone have the experience on how to config the parameter of GZP_TX_RX_TRANS_DELAY in function...
I have a peripheral running the S110 stack, which presents a characteristic to which I want the central (running S120) to be able to do a long write. What I've been trying...
Hi all,
I have been trying to combine the UART and hID Keyboard examples into a single application.
I want to use the HID part to send specific keystrokes using buttons...
Hi, I'm new to BLE and just started feasibility testing, using RF8001, on a small device with no IO. The device will have a unique code set at factory, and printed on label...
I am trying to accomplish the following very simple task: use the broadcasting function of my nrf 8001 to send up to 19 Bytes of data over the air (connectionless).
I tried...
I need to create a backlight fade-in/out effect. For this I'm using the latest nrf_pwm lib form here together with the S110 Softdevice. Using the scheduler and an application...
Hi All,
We have been working on Arduino Mega board with BLE shield. We want to get the address of the BLE shield and we are using aci library for that.
I found this...
Hello,
Im using the master control panel app from nordic to use the DFU.
I can only once upload the application over DFU on my nRF51422. Because after the upload is...
Hi,
I have been trying to connect to a proximity tag and stay connected but with no luck. What happening is that the unit connect does its thing and then disconnect with...
I use a OLIMEX nRF8001 module with ATMEGA328 at 3v3. Using the "helloWorld" serial example sketch, I measure a current of approx 400-600uA. However, if I use the calculator...
Hi Nordic
I want to test parameter about output power 、sensitivity and so on ,but we have not software tool . Could you tell us how to test and provide tool to me .
...
Hi,
How to set user description descriptor to a particular attribute? I have created one primary gatt service with more than four characteristics, when is see it through...
Hi,
Master device is whole the time in receive mode and I have a problem with read data from device which address is in Pipe1. IRQ appear and status is 0x4e and FIFO status...
Hello, I bought the nRF51822 Development kit and the nRF6700 starter kit and I'm having trouble finding tutorials on how to use the 2.4 GHz radio mode on the nRF51822. Can...
Hi everyone,
I have some strange behavior with a central peripheral combination. My central subscribes notification on the peripheral. This has a limited TX-Buffer for just...
Hi,
I am developing the nRF51822 for the BLE device application. For the data delivery I am implement this function based on "button_radio_example(Tx/RX)" example code. It...
Hello,
I have been since many days desperately trying to set the bytes in the advertisement packets in my Arduino, combined with an NRF8001.
What I am trying to achieve...
