Hi,
I'm using nRF SDK 16 for my application on the nRF52840 custome board. When I set both parameters (i.e., support for coded PHY and 1M PHY ) in the scan initialization...
Hi all,
I'm working on a Nordic-based system involving multiple nRF52-series chips exchanging high-rate sensor data over both radio and SPI links. The setup involves two...
Howdy!
I am attempting to develop a system using an nRF52840 and an ADS131M04EVM (ADC). Our application requires us to collect data at a high sampling rate (>= 16k SPS...
I have a nrf9160 DK but when upload SLM application to it i can not send AT commands to it over it's usb port but in asset tracker application it works i want to modify SLM...
Finally we got our prototype boards and proof of concept firmware code done and we are a bit stuck on the average power consumption over time for the entire sensor that is...
We are implementing a Joiner device using OpenThread on the nRF5340 (with Zephyr, NCS v3.5.99-ncs1-4). After successfully joining the Commissioner's network ("Join success...
Hi,
I have integrated Neuton’s “Transport Type Detection” pre-trained model into my firmware, running on a nRF52840dk. For collecting 9-axis IMU data, I’m using the ST X...
Hello,
Is there any methods to implement the "long press wake-up"? Pressing the button for 3 seconds to let device enter sleep mode and pressing the same button for 3 seconds...
Hello, I have a question.
The chip uses nRF 52832. MDK keil μVision V 5.22.0.0 is used as the development environment.
I am using nRF5_SDK_13.0.0-1.alpha_055eef3.
It...
Since September I get multiple warning messages on projects that use both the nRF51822 library and the mbed library. This is even true for example projects for the 51DK board...
Hi,
I put my nrf51 into power-on sleep mode by calling sd_app_evt_wait().
When I walk away with my mobile phone, the bluetooth disconnected and my nrf51 can receive...
Hi there,
I am currently working on a custom GATT profile for constant data streaming. I have to keep to GATT because I need multiple attributes to keep track of different...
Hi
I saw the Central and Peripheral example code has peer_manager in sdk 12.2 and BONDING_ENABLE in sdk10.
What are they does and where has document I can read.
If I...
From the Nordic errata [141] on NFCT not stopping HFO when going from activated state to sense state:
Workaround:
Power cycle the NFCT using the POWER register, then issue...
Hello.
EDIT: When I connect to nRF52832, Windows are not creating bluetooth serial com port. And Bluetoth Services are not getting.
How Can I do this??
Thanks.
Hi.
Is it possible for the NRF52840 to act as a USB host? or is it "only" a USB slave?
It would be awesome if we could connect a usb peripheral directly to the NRF52840...
I'm confused.
in other platform, i know flash stard and end adress ,alse page size ,i can read and write data directly.
But use pstorage mode as follows :
pstorage_init...
Hello,
I want to bring some data by UUID.
I know the ble_nus_init() can set UUID and I know it was set by sd_ble_uuid_vs_add().
But this way only change the UUID while...
Hello.
I loaded Soft Device and UART example on the board. Then I connected Nordic_UART through by Bluetooth.
And I want to add a virtual COM PORT on Win10. I entered...
