Hi, I have a question about Channel Sounding. For my design, I want to use 2 antennas on the initiator and 1 antenna on the reflector. My initiator hardware has an RF switch...
I want to verify the 4Mbps transmission mode of the nRF54L15 series through ESB samples.But the highest value measured so far is 2.34Mbps, which is much lower than 4Mbps....
Hi, nordic team
There is an issuse happened in my custom board with nrf52833,programming in ncs v2.9.0.
peripheral side is programmed base on peripheral_hid_keyboard and...
Hi all,
We are currently developing a modem application for use with a Linux host, based on a nRF9161 using nRF SDK 3.0.0 and toolcahin 3.0.1
When compiling the Serial...
Hi,
I'm using nRF SDK 16 for my application on the nRF52840 custome board. When I set both parameters (i.e., support for coded PHY and 1M PHY ) in the scan initialization...
Hi all,
I'm working on a Nordic-based system involving multiple nRF52-series chips exchanging high-rate sensor data over both radio and SPI links. The setup involves two...
Howdy!
I am attempting to develop a system using an nRF52840 and an ADS131M04EVM (ADC). Our application requires us to collect data at a high sampling rate (>= 16k SPS...
I was doing some range testing using the ack payload feature of nRF24L01 modules, and I noticed that using different packet sizes would affect the number of packets per second...
Hi
I have a MCU with an external sensor connected via SPI sampling data at 1000Hz.
Using the nRF8001 with REQN and RDYN lines is making trouble. The REQN line is pulled...
I am trying to accomplish the following very simple task: use the broadcasting function of my nrf 8001 to send up to 19 Bytes of data over the air (connectionless).
I tried...
I need to create a backlight fade-in/out effect. For this I'm using the latest nrf_pwm lib form here together with the S110 Softdevice. Using the scheduler and an application...
Hi All,
We have been working on Arduino Mega board with BLE shield. We want to get the address of the BLE shield and we are using aci library for that.
I found this...
Hello,
Im using the master control panel app from nordic to use the DFU.
I can only once upload the application over DFU on my nRF51422. Because after the upload is...
Hi,
I have been trying to connect to a proximity tag and stay connected but with no luck. What happening is that the unit connect does its thing and then disconnect with...
I use a OLIMEX nRF8001 module with ATMEGA328 at 3v3. Using the "helloWorld" serial example sketch, I measure a current of approx 400-600uA. However, if I use the calculator...
Hi Nordic
I want to test parameter about output power 、sensitivity and so on ,but we have not software tool . Could you tell us how to test and provide tool to me .
...
Hi,
How to set user description descriptor to a particular attribute? I have created one primary gatt service with more than four characteristics, when is see it through...
Hi,
Master device is whole the time in receive mode and I have a problem with read data from device which address is in Pipe1. IRQ appear and status is 0x4e and FIFO status...
Hello, I bought the nRF51822 Development kit and the nRF6700 starter kit and I'm having trouble finding tutorials on how to use the 2.4 GHz radio mode on the nRF51822. Can...
Hi everyone,
I have some strange behavior with a central peripheral combination. My central subscribes notification on the peripheral. This has a limited TX-Buffer for just...