Hi
I have one nordic nRF54L15 DK using as peripheral, I want to know the power of it. Thus, I use PPK2 to be a 1.8 voltage source and connect VOUT to P6 pin 1 and GND to...
How do I produce a signed file to flash to the network core for firmware update? I am using a child image/parent concept with the \nrf\samples\ipc\ipc_service\ project, When...
Hi,
I’m working with the Wi-Fi station example on the nRF54H20 using SDK v3.0.0, and I’m encountering a critical issue when trying to bring up the nRF7002EK Wi-Fi module...
Hi Nordic team,
I'm trying to configure the GPIOs to operate at 3.3V using the nRF Connect for Desktop's Board Configurator tool (v0.3.10). The tool works as expected...
I have a project using BLE as a central on an nRF5340 to connect to several devices. For factory test I am being asked to implement something that can be used in the factory...
Hi,
I have designed a custom board, and I cannot get coexistence interface to work reliably. I don't get any errors, but I'm not able to connect to my board with BLE. WiFi...
Hi
Could you provide the power current in System on Active, System on Sleep, and System OFF for nRFready Desktop2 keyboard and mouse? nRF51 was programmed Desktop 2 v1.0...
Hello,
I am working on the factory test mode and I want to add a carrier test, is there a function from the S110 softdevice library that I could use?
Thank you for your...
Hi,
I set up eclipse according to n-AN29 and imported several of the example projects. The blinky_example project described in the nRF51822 dev kit user's guide works perfectly...
Hi, I have been trying to maximize the baud rate of my uart module, I am using the app_uart layer to control the uart and I have noticed that in your implementation of HCI...
I have an ultra low power application that needs to broadcast it's proximity on a 1sec interval. However, about 75% of the day I would like the device to be powered down and...
Hi all
Now I can use Keil to compile/load/execute the example project, for example blink.uvproj.
But how to execute/debug on ble_app_hrs example ?
Keil will hang on a...
I am looking for details on the internal temperature sensor on the nRF51822. I would like to use it to get a general ambient reading of the air around the device. Basically...
I want to get RSSI between PCA10001 and PCA10000. As you known, I have to make these two device connected first. If I write my code based on the example of UART, are these...
Hi,
i need to start my application while pressing two seconds a button. For this i use an gpiote event like here --> devzone.nordicsemi.com/.../how-to-use-app_timer_cnt_diff_compute...
hi everyone.now i am developing a project with nrf51822.i am using the PCA10000 dongle to see some information of advertising packages. i moved out and pluged in the PCA10001...
I'm attempting to load the ant-fs reference design to two different nrf51422 evaluation boards. The application builds successfully but I am having difficulties loading it...
Hi
my application is a 9-axis battery driven motion sensor with a data rate about 144 bit per packet at 1000Hz i have to transmit over air. Low latency (<10ms) is extremely...