Hi,
I am trying to use nfc_t4t_lib and I have some issues because processing incoming data takes some time (around 100 ms) and therefore sending the response occurs late...
I'm not sure if this is the right place for this question.
I'm using the Settings subsystem for the BLE name.
When BLE is initialized inside matter, settings_load is only...
Dear devzone，
Based on ncs2.9.1 and nRF54L-DK(v0.9.2), add in the prj.conf of the peripheral_uart example:
Compile and burn to nRF54L15-DK, the program does not run, and...
The nRF54L series is a new device to the nRF family, and during the bring-up of the chip from early engineering samples to mass production devices there have been quite a...
Hey, Can anyone tell me what is wrong in this routine for device information service initialization? It shows manufacturer name, hardware revision and firmware revision characteristics...
I'm looking for help figuring out why my nrf51422 isn't waking up to advertise, I'm missing a detail but I don't know what it is. It works great, until sd_power_system_off...
Dear Nordic Team,
Thanks for supporting.
I am using PCA10028 hardware and SDK is SDK12.3.0. I want to use two adc channel one for connect with battery sensing and another...
Hi,
Just a quick question about the chips included in the nrf52 development kit.
I have two sets of the nRF6827 Rev. 1.2.1 kits, each kit included 5 cut tape chips. Are...
No matter flash is full or not, calling fds_file_delete() and fds_gc() does not free storage. We checked the content in flash are not 0xFF. Moreover, after this issue, always...
Hi,
I'm wondering if it's possible to set hopIncrement (Core4.2 Vol6 PartB 4.5.8.2) to a specific value (not random), like 5, in current SoftDeivce. Also, if that's possible...
I've been playing around with the SDK these past few days using both Keil and ARM GCC options.
When people develop a product using this SDK, do they just clone one of the...
Looking at
\NORDIC\SDK\examples\peripheral\spi\pca10040\blank\config\sdk_config.h
These lines repeat over and over. Was there a reason for this? The first time the infdef...
I just nRFConnect to find the JLink on a Mac. JLink is connect to the devkit, a BLE400. As soon as I select the com port, nRF Connect asks me if i want to install the latest...
I was wondering what material was used for the Thingy52. I'm guessing the top was some type of cast silicone while the bottom is some type of PC. Part numbers of the exact...
Hi, I just want to know,
Is it possible to develop a device that advertise normally and be connected by mobile, but the device must always send the eddystone-format advertising...
Hi,
I wonder what transfer speed can be expected on a BLE DFU update on a nRF52832 based device in the following condition?
-SDK14.0 Secure DFU, nRF52832, Android tablet...
I get an app error SOFTDEVICE: INVALID MEMORY ACCES if I try to write/clear RESETREAS after the softdevice has been enabled.
Why is this happening?
You can reproduce...
Hi
I'm using a nRF52832 togehter with the SoftDevice SD132 and the SDK V12.2.0. I encounter the problem, that the SoftDevice runs into the softdevice_fault_handler(). The...
Hi,
I'm using the ble_app_multilink_central example in the newist SDK nRF5_SDK_12.1.0_0d23e2a, nRF52832. Now it can printf the log information. I want to use the uart to...
