Hi,
Recently I want to set up a dynamic network that with the node change this position ,the network will change dynamically.But there is the question,with the node's position...
Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
I am working on code to setup a bond manager for ancs based off of the example, but have a fixed advertising and connection interval of 25ms. How does the bond manager and...
Although I have already seen this discussion ( https://devzone.nordicsemi.com/f/nordic-q-a/35183/no-idea-how-to-get-manufacturer-specific-data-in-central-side-from-advertising...
Hello,
I have an nRF52840 chip ( Holyiot nRF52840 module ) and I want to program the chip using an nRF52840 DK. The Holyiot module is basically an nRF52840 mounted on a...
I am having trouble turning on bonds for DFU.
First of all, before I describe this pain, can I choose to avoid this battle by just allowing unbonded devices to DFU? e.g...
Hello!
I just bought the Beacon Kit and i was following the user guide v1.1 and I have some questions about how to use DFU. I have already downloaded nRF Toolbox app.
...
Hi,
I am using fatfs of nRF5_SDK_15.0.0_a53641a. I am writing a program with keil.
I want to know how to write the value obtained from the sensor to the SD card. ...
I am using proximity profile in sdk15 with softdevice 6.0.0 . I added flash write, writing continuously some data to flash. But it working sometimes only.
Hello,
at the moment my application is accepting more than one device if its not connected to anything. But I want that the application only connects to one device and...
Hello, i am using NRF52840 board with SDK 15.2. I am trying to read data from an advertising packet and i was just wondering if anybody on here had a good parser i could potentially...
Is it possible replace HRS to UART service (like ble_app_uart) on BLE LE Secure Connections multirole example project?
Any suggestion to easy to modify it?
Hello,
I am trying to get CLI working over UART and simultaneously use RTT for logging. I don't quite get my head around this. My platform is the nRF52840 DK. I am using...
Hi everyone,
I'm developping on nRF52840 with SDK 15.0.0 and Softdevice S140 v6.0.0
I'm using Peer Manager for pairing and bonding.
Everything work fine with io_caps...
The only examples I've found have been for ordinary single ended measurements at lower resolution, and even that is a crazy number of lines of code. Surely by now there is...
Dear nordic,
I want to change advertising data(manufacturer data including company identifier) before i start advertising
i choose central and peripheral example(because...
When I use the uart to transparently transmit, there is no problem at around 4k/s. When I increase the transparent transmission rate, there will be NRF_ERROR_SVC_HANDLER_MISSING...
