Hi,
We are using nrf21540 in GPIO mode + mode pin ( and CONFIG_MPSL_FEM_NRF21540_RUNTIME_PA_GAIN_CONTROL) with an nrf52833.
We are developing under nrf connect sdk 3.0...
During the development of a Matter over Thread product, I encountered the following issue:
After adding two Matter over Thread devices (an OnOff Switch and an OnOff Light...
Hi Nordic Teams :
I would like to check the current consumption by BLE DTM.
1. Is the table measurement is from 3.0V input?
2. I find the condition in the datasheet...
HI ALL,
nrf54l15dk,v2.8.0,peripheral_uart demo and no changes have been made.
Then add the following content to prj.conf
sysbuild.conf
mcuboot.conf
At this...
Hi,
I am programming with ncs v2.9.0, nrf52833 chips.
I am going to get pc keyboard led state in my custom board throutgh BLE.
This is my report map,but cannot get data...
I'm developing my application with nrf 52832 and nrf SDK v17.
I know NCS is more powerful. I'm currently learning how to use it.
But now.I still need my application with...
I'm writing a wav file from the nrf52840 board to the nor flash w25q128jv with a capacity of 16mb but it seems that I can only operate on the first 2mb, even when dividing...
modify ble_app_uart example。
I change the #define to another value：
But whether lightblue or nRF connect，It only change the advertisement's UUID.The Characteristic is...
hi,
im trying to implement a one shot timer and followed the tutorial here:
devzone.nordicsemi.com/.../
note that i adapted the code for a custom project (and a custom...
According to nRF52832 Product Specification v1.3, tPOR is written as follows.
Is the VDD rise time range from 0 V to 1.7 V or from 0 V to 3 V?
Please tell me the range...
Hello,
I'm trying to change advertisement packets, I found this link text
it says:
p_data Raw data to be placed in advertising packet. If NULL, no changes are made...
Hi, I'm trying to change ad packets in the blinky example. I want to be able to keep blinking but change the ad packs (don't know if this make sense, but main goal is to change...
I have created a build system that will install openmesh on simblee chips, and it appears to be mostly working. However, range is very poor, like max 2ft. I have tried adjusting...
Hi guys,
I am working with a central battery powered so, I am controlling the RF activity calling scan_start() or sd_ble_gap_scan_start() and disabling the RF activity...
Hello,
We are switching chips from the nrf51 to the nrf52832. I have a nrf52-DK board now. My Eclipse set up is still able to compile, run, and debug my nrf51 projects...
hi,
im a little lost with BLE at the moment. all i want to do is sending 3 bytes of data (sensor data) approximately 10 times (+- 5) a second (when the uC is not sleeping...
As a central, I am writing to a variable length characteristic, advertised by a service of my peripheral. In this case, I am sending 80 bytes of 0x01 as a test
uint8_t...
I used the ANCS program in sdk12.3.0, I have closed the white list function, I use the iphone connection and paired, then I ignore this device on the phone, and then I use...
Hi
I am using nrf51-dk board along with the S130. I am getting the following message when I debug my code. The central link count is set to 0 while peripheral link count...
