Hello. I am literally looking at the set_hrm_cccd function in Python used to write data. This is for the S130 heart rate collector example. I understand the sd.ble_gattc_write...
Totally new to Python but managed to get things like pyserial setup and I've been able run the ble sniffer. However that is as far as my Python knowledge extends, so I need...
pstorage_load and pstorage_clear appear to work fine, but whenever I do a pstorage_store the callback function is never called. This happens whether or not the Bluetooth unit...
Our USB keyboard using nrf24lu1p does not work on Mac OS 10.11.
Before Mac OS 10.11, USB keyboard was worked, but on Mac OS 10.11, it does not work.
I think your library...
In my design I need the RX to be standalone , I.E. no controller attached to it , does the programming STORE in the Chip ? If I set it up as a RX and set a specific Ch. Freq...
[Dev Env]
nRF51 DK
IoT SDK 0.8
IoT SoftDevice
[Question]
how i change my ip in ipv6_coap_server example use ipv6_address_set / ipv6_address_remove API.
To...
Hi Guys,
I have a MCU RTOS project. in Hardware board, builtin Nodic BLE chip over UART,RTOS BLE stack works fine.
We also have a MCU RTOS Emulator based on Qemu,we...
I have one characteristic which send data with indications, for each frame sent I wait for acknowledgement on case BLE_GATTS_EVT_HVC : before sending the next data
but...
I write a source code to test led and button driver. it's work with a loop but when add sd_app_evt_wait() to use low power mode of nRF52.
I suppose that I forgot something...
Hello,
i have one problem.i am working on the TWI using Handler.it is working.
but i have very strange issue regarding to the dereference the value.
please check in...
Hi,
I am facing some issue while working with both GPIOTE and SAADC. I have merged the GPIOTE and SAADC sample example sdk code into a new project but what I am facing is...
Hi,
I am using BSP for button detect. I wish to read the button Long Press of Different intervals. 3 Secs, 5 Secs etc.
Someone please help me achieving this. Some code...
According to the documentation in infocenter there should be three soft devices for the nRF52832: 132, S212, S332. I downloaded the nRF5 SDK and I can only find the hex file...
Hi all,
Does anyone know the dimensions of the NRF51 dongle? I'm seeing 16mm x 28mm here but that doesn't seem right (might be the dimensions without the USB connector...
Hi,
Can any one suggest me how to program SoftDevice and Application program to nRF51288 BLE Motherboard using Keil 5? Please specify how much IROM1 and IRAM1 allocation...
I've studied the nRF OpenMesh for a couple of days, and could run the BLE_Gateway example among serval nRF51DK boards.
But now, I still don't have any feeling/concept about...
Hi, I’m looking for a data streaming solution to wirelessly transmit data over a short distance. Important points are:
unidirectional point-to-point transmission
...
Good morning,
my problem is that this module has a very short range.
The maximum range that I found was 4 meters.
Have you any solution for increasing this range?
Thanks...
Hi,
I saw several structs that you have in your library and I am curious as how you are forcing the alignment, since I want to do the same.
This is one of them:
typedef...
