The document nRF51422_Evaluation_Kit_User_Guide_v2.0.pdf says:
Locate the Heart Rate demo project found in the folder
ARM\Device\Nordic\nrf51422\Board\pca10003\s310\ble_app_hrs...
Using the nRF Beacons app, but cannot see the battery condition of each beacon. Is this already implemented - if so how to turn on? If not how is it implemented?
Using the nRF Beacons app, but cannot see the battery condition of each beacon. Is this already implemented - if so how to turn on? If not how is it implemented?
Hi All
I am doing a BLE based project using nRF51822.Where i need to handle the message [with UUID] by using ble_gatts_char_handles_t.
so, can any one please share information...
I have a central application and peripheral application that are based on the multilink-central/multilink-peripheral examples.
I've modified them to run on the PCA10001...
Hi All,
I'm using nRF24L01P for TX device and want to receive packet from nRF51822 RX device.
nRF24L01P TX device Register settings are as follows;
Reg.EN_AA=0x00...
I am trying to develop for some nRF51822 mbed boards, and I would like to use the S130 SD to enable both central and peripheral behaviour. The machine I'm using for development...
Hi,
I am trying to make a program for the NRF51 development kit on mbed. I have been able to take ADC samples at 1000Hz which is what I want, but I can't seem to print...
In SDK 11 description od DTM "vendor specific" settings, there is a lot of inconsistency in parameters names/numbers - could anyone help me understand this part?
As for...
Hi,
Everyone,
I have firmware working with our custom pcbs.
It works fine with new 3.3v battery.
But somehow it does not advertise anything with used battery having...
I have a digital microphone chip, it has the CLK, DATA, LR_SEL three pins, now I will pick up the three pin nrf5283 three pin is as follows: CLK connectionI2S_CONFIG_SCK_PIN...
I guess we need some help with definitions. Basically, we'd like to read data from an I2C line. Should be as simple as "set to input" and "read the pin". However...
In...
Using nRF5 SDK v11.0.0, I am working on bringing up new hardware based on the nRF52. I started with code that works on the PCA10040 development board in which we connected...
I need to calculate radio on time in IoT SDK but IoT softdevice don't provide ble_radio_notification (in sdk components) and nvic functions (don't have nrf_nvic.h in softdavice...
My scenario is I have an android device and 100+ advertising nrf52 devices. Is it possible android to receive/scan advertising packets (small) from 100+ devices which mean...
error occurs in nrf_delay.c of nrf52832
Because there are ASM in nrf_delay.h
nrf_delay.c:
#include <stdio.h>
#include "compiler_abstraction.h"
#include "nrf.h"
...
Hello,
I cannot find an example in the current SDK on how to use APP_UART. I do not want to use app_uart_fifo because it has quite some overhead that I do not need. All...
I am using nRF5_SDK_11.0.0_89a8197 to test esb maximum throughput.
in the macro definition of NRF_ESB_CREATE_PAYLOAD,
#define NRF_ESB_CREATE_PAYLOAD(_pipe, ...)
...
On the nRF51, there are 5 OVERRIDE registers (0-4) in the radio module.
What do those registers do and when should they be used? The FRM was not clear about them.
