I have a zephyr zbus project running on the nrf52840DK that’s working well. We want to port the project to the nrf54H20DK, but I’m having trouble seeing the log messages....
Hi all,
we are wondering if there is a clean and reliable way to perform DFU on 54L15 via Thread? Our scenario: once the products get shipped to customers, the border router...
Hello,
We upgraded our project to nrf connect sdk v3.0.2 from v2.9.0 and can no longer use pin 0.00 and pin 0.01 as gpio. The problem seems to be in the nrf53 soc.c file...
Hi I am developing in 54L15. Now use DPPI to link
TIMER10's PUBLISH_COMPARE[3] ---> RADIO SUBSCRIBE_STOP,
it works fine.
Now I want to trigger a GPIO signal through...
Post:
Hi Nordic Team,
We are currently developing a product based on the Raytac MDBT50Q-1MV2 module, which integrates the nRF52840 SoC. Our firmware is built using the...
I use the security mechanism dtls based on udp communication. Can I implement it on nrf52833? How much flash and ram should be occupied at least? Is there a suggested value...
I am testing gnss without lte connectivity, which seems to work ok.
Except when I get "The modem has detected a reset loop. LTE network attach is now restricted for the...
I am looking for details on the internal temperature sensor on the nRF51822. I would like to use it to get a general ambient reading of the air around the device. Basically...
I want to get RSSI between PCA10001 and PCA10000. As you known, I have to make these two device connected first. If I write my code based on the example of UART, are these...
Hi,
i need to start my application while pressing two seconds a button. For this i use an gpiote event like here --> devzone.nordicsemi.com/.../how-to-use-app_timer_cnt_diff_compute...
hi everyone.now i am developing a project with nrf51822.i am using the PCA10000 dongle to see some information of advertising packages. i moved out and pluged in the PCA10001...
I'm attempting to load the ant-fs reference design to two different nrf51422 evaluation boards. The application builds successfully but I am having difficulties loading it...
Hi
my application is a 9-axis battery driven motion sensor with a data rate about 144 bit per packet at 1000Hz i have to transmit over air. Low latency (<10ms) is extremely...
Hi,
is there any Example to use the UART ?
I need an monitor while the application is running, is the UART COM Port the right one for this?
Is there an example with...
I need a mutex and I found this information at the ARM site: infocenter.arm.com/.../index.jsp
Is there anything I should be aware of in using this technique to implement...
I have a central device , that acting as a gatt server. the service is customize, and 128bit- primary serivice UUID ,its characteristics' UUIDs(128bit) are all known, how...
How are the four RAM banks divided up in the nRF51822? Is it an even split of the 16K total RAM (i.e. 4K per block)?
Furthermore, can I expect strange results if I turn...
Hello, sirs.
My question is how to configure clock in gazell protocol on nRF51822
I look at the example gzp_dynamic_pairing but that does not have a code part of modifying...
