I am trying to find out the part number of the antenna (I assume it is a PCB antenna) used in the nRF51 DK ( www.nordicsemi.com/.../nRF51-DK) . I found a lot of similar questions...
Hi.
I am using the NRF52 Development board, on Keil uVision, to implement a C program that uses Dynamic Structs. The Structs re-size themselves ( by increasing their capacity...
Hello,
I have an NRF51822 (redbealab ble nano) that I would like to use to count pulses in very low power mode.
Pulses are asynchronous
The rate of pulses can...
Hi
I'm attempting to read a PT-100 sensor value that is part of a voltage divider using a nRF52.
Both the reference resistor and the PT-100 is sampled while the voltage...
Hi
I have been searching the forums, but were not able to find an answer to my question.
I'm trying to sample 4 analog inputs on the nRF51-DK using the ADC hal. (SDK10...
Hi
I have been trying to get two NRF24L01 chips communicate with each other since a week now, without much success. All what I can find on the net is Arduino examples using...
Hi
I have done several projects with the nRF905. I know the device quite well. Normally I use the CD, AM and DR interrupt pins to determine the status of the device, my current...
Hello,
We're looking for easy way to communicate between nRF51822 configured as central part with C# application.
Ideally we should use standard firmware which forwards...
Hi,
Im trying to monitor the high voltage im generating with PWN using ADC. I also need to run BLE at the same time to provide results.
So far I dont have any luck and...
Hi,
Why you use a Hex format file for the firmware with a Toolbox Android, then the IOS Loader you use a binary format file ?
Because I would like use the same file. ...
I have a nRF51822 and arduino uno board. Is it possible to connect my nRF51822 uart to the arduino rx/tx, so that i can use it for communication to PC through arduino. The...
I'm having some problems when flashing the mbed enabled nRF51 kit. This is currently my environment:
When I try to download the file I always get this error: "Cannot Load...
Hello all,
I have two services which has characteristics with indication only property. I am using sensor simulator to generate values. When i write first CCCD write of one...
Hello,
I have been searching for GPIO documentation, particularly on interrupt configuration, and I have come up short. Can someone send me a link where I can find more...
As we know, there is a solution of wireless charging in nordic. I just want to know where is the Bluetooth stack in the solution? In SOC or in Bluetooth controller? If In...
Hello,
I am using nordic development kit nrf51822 and i was trying some examples of it as given. But in that in one example there is one function
static void gpiote_init...
I am aware that the debugging interface draws significant current, I do not believe that is the case.
I have 2 designs in front of me. Let's call them '2.0' and '3.3' ...
Hi
I'm a little confused with the RAM usage with S110 support, the following represents the memory usage of example of "ble_app_template", even there is no any application...
Hi,
i want to know
how to sink mobile and softdevice in BLE or WIRELESS(having 4.0 stndrd)?
how to send BCON from nrf51288 board in order to set connection with...
Hello,
We have started down the path of getting our first Bluetooth Smart product through the Bluetooth qualification process. We are using the nRF51822 with SDS 6.0.0...
