But now I have a new problem that is whenever I set " PWR_UP " bit in CONFIG register then it drop the 3.3 volt vcc to 1.2 volt. I don't know why its happening. Anyway, is...
This previous question about multiple advertisements seems to be related to softdevice 7. I was unable to get a similar example working in SD/SDK8
My end-goal is to add...
We are considering using Gazell for an outdoor application, i.e. lots of noise and disturbances, constantly changing environment, where the amount data being transferred is...
Hi everyone,
I have found your git "Ble Optiboot"( github.com/.../ble-optiboot) , and I have understood, it is usefull to load a binary into MCU flash, I was looking for...
I'll go ahead and describe what I need to do and see if anyone might have some place to start for me since I'm having a lot of trouble figuring out what I need.
I'm looking...
Hello ,
I'm designing an embedded system with one of your RF chips (NRF24L01+) and as far as I searched for the datasheet , It seems like NRF24L01+ doesn't have a hardware...
Hi,
This post is very old.
devzone.nordicsemi.com/.../
I have a nrf51822 chip and I'm using it as BLE and it exposes some service and characteristics and it is working...
hi，dear.
I designed the hardware according to the datasheet of NRF52832, version 1.4, Page 545,Figure 169: QFAA and QFAB QFN48 with internal LDO setup.
In the picture...
Does anyone know of any current Apple devices (and a supported iOS version) that support extended advertising? I'd like to download the nRF Connect app on an Apple device...
SDK 15.3.0; nRF52832
In a previous discussion about continuing to advertise while connected:
[quote userid="4240" url="~/f/nordic-q-a/45644/how-do-i-simply-do-a-non-connectable...
Hi,
I've developed firmware for nRF52832 to beacon and scan for identical beacons. So with many devices, each can detect the others. What I've noticed is that while most...
Hi,
I am using the Zigbee CLI to maintain and control a Zigbee network. The Zigbee stack is running on a BMD340 module. I added a Ikea Trådfri dimmable light bulb (only...
Hello,
I'm developing a coin-sized board based on the nRF52840 and the nRF52833 in aQFN73 package. The PCB has only two layers with the bottom layer dedicated to ground...
I saw that in SDK there are examples with tcp, dhcp and etc of iot. If some router have usb port, is it possible somehow to configure nRF52840 as part of network infrastructure...
Hi All
I am using nRF9160 and read a value from Fuel Gauge IC (LC709203f) via I2C so I use i2c_scaneer sample
so I just a little bit confused what should I change in...
According to the nRF52832 spec, the flash memory can handle a minimum of 10K write/erase cycles. I need to understand the following:
I understand the write/erase cycles...
Hi team,
We are using Raytech nrf52840 dongles as NCP connected through USB to RaspPi compute module. We would like to upgrade the NCP application in the field using DFU...
Dear nordic,
I have an application that developed using development kit pca10056. I want to change it to supporting nRF52811. I want to test the long-range feature of nrf...
Hello. I'm a CS student and I've bought myself two NRF52840 Dongles. I've downloaded NRF Zigbee SDK and wanted to flash and try out some examples. But the simplest light_control...
