Hi,
Recently I want to set up a dynamic network that with the node change this position ,the network will change dynamically.But there is the question,with the node's position...
Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
I am working on code to setup a bond manager for ancs based off of the example, but have a fixed advertising and connection interval of 25ms. How does the bond manager and...
Hi,
I did some benchmark on internal flash access and found it takes more than 2 seconds for the device to write 16kB data. I timed by "nrf_fstorage_is_busy". Is this normal...
Hello,
I am using the sd_ble_getts_value_set() function two times in a row on two different characteristics. Both characteristics are part of the same service.
At the...
Hello,
I am really new to using the Nordic nRF51822 and I'm having problems making SPI work with the S110 SoftDevice. I was able to combine the sample codes spi_master_example...
I am using a nRF52840 PDK and trying to config 8 buttons.
(1) GPIOTE_CONFIG_NUM_OF_LOW_POWER_EVENTS to 8 (sdk_config.h)
(2) Add buttons define (pca10056.h)
Button...
I've been trying to run some of the examples provided with the SDK's. Blinky is the only one I've gotten to work for sure. I think I haven't set up the linker scripts properly...
I am looking at using two Nrf52840 on Custom PCBs to create a wireless link from my product to a PC one 840 would be the host and would be wired to the PC using USB (HID,MSC...
I know this has been asked a few times, but I am having a hell of a time receiving a ACK packet from my nrf24l01+ receiver (PRX). I am able to successfully send packets from...
Hi,
I just spend a day trying to get the nrf_sniffer tool working.
The
devzone.nordicsemi.com/.../
contained some very useful info but unfortunately it seems i am...
I have a USB host capable Android device running CentOS via Linux Deploy and everything is working perfectly except i'm unable to connect to my USB nRF24LU1+ Crazyradio PA...
Currently, I am trying to run the semtech lorawan code on nrf51822 with sx1276. I have successfully porting the ping pong code to nrf board and also able to send packets from...
I can no longer use the BLESniffer software with nRF51 dongle because it won't reprogram with Ctrl-R getting an error suggesting using nRFgo Studio to reprogram it. Which...
Hi,
Apple has released the specifications of HomeKit for hobbyists and non commercial use ( developer.apple.com/.../).
Do you (Nordic) follow Apple by releasing a hobbyists...
Hello i am new to nordic BLE chip. I want to put security feature. i.e. when i press push button by this GPIO library. BLE should be visible only for that time frame, can...
Hi,
I am trying to flash program an nRF51822 module to operate as both central/peripheral role.
So I'm looking for some advice on how this could be done?
Programming...
