But now I have a new problem that is whenever I set " PWR_UP " bit in CONFIG register then it drop the 3.3 volt vcc to 1.2 volt. I don't know why its happening. Anyway, is...
This previous question about multiple advertisements seems to be related to softdevice 7. I was unable to get a similar example working in SD/SDK8
My end-goal is to add...
We are considering using Gazell for an outdoor application, i.e. lots of noise and disturbances, constantly changing environment, where the amount data being transferred is...
Hi everyone,
I have found your git "Ble Optiboot"( github.com/.../ble-optiboot) , and I have understood, it is usefull to load a binary into MCU flash, I was looking for...
I'll go ahead and describe what I need to do and see if anyone might have some place to start for me since I'm having a lot of trouble figuring out what I need.
I'm looking...
Hello ,
I'm designing an embedded system with one of your RF chips (NRF24L01+) and as far as I searched for the datasheet , It seems like NRF24L01+ doesn't have a hardware...
Hi Engineers!
We used SDK13 for our Project (multilink BLE with 1xServer & 4x PeerS) and now move to SDK14.2, almost done except only USBD.
if we use SDK13 driver...
I've already tried before using ADXL345 using nRF51822 using mbed compiler this is the link.. os.mbed.com/.../
but that program can't get ADXL345 data, just UART nRF51...
I'm trying to debug a project I recently migrated to eclipse but my Peripheral Registers are empty with the error message "There are no peripherals descriptions available...
I'm building a new application based on the no softdevice template example. I pulled in the code from the UART BLE example to redirect printf to the serial interface and that...
Seems i can not find where nrf_dfu_set_adv_name_init is defined? It seems not in SDK source files, neither can find any sign on SDK documents.
Thank you.
Hello,
I have a nRF52832 Breakout Board from SparkFun. I can see from their tutorial that I can program this board using the serial bootloader that they have burned into...
Hi everyone,
I make the project whith nrf51822 BLE module and need to configure the bluetooth service characteristic as input/output for reading and writing the string-information...
Product: nRF24Lu1+
If I use the nRFGo and the nRF24LU1+ Development kit, must I use the Keil tools to be able to access the debugging port? I develop in linux and use the...
Hi everyone,
My configuration:
nrf52832 microcontroller
Softdevice S132 V4.0.2
Nordic SDK 13.0
IDE: Eclipse
I'm working with a "Stand-alone can bus controller...
Hello All,
I am working nrf51DK and i am using ble_app_uart application with s130 softdevice.
Now my query is I am trying to send some data from my mobile application...
Hello Pros,
I maybe running the nRF52 close to its limit. It appears to have a probability of 1/1000 to 1/2000 to hit a 3004 in a continuous time-gated packets stream....
Hi,
I have created a custom service, and now I want to add different characteristics to it but with completely different uuids, not only the 12-13 octets.
This service...
Hello All,
I am working on nrf51dk , we are facing the issue if we send > 8 bytes of data in one time from Uart console then BLE_NUS will reset..
Our Setup:
ECU --...
