But now I have a new problem that is whenever I set " PWR_UP " bit in CONFIG register then it drop the 3.3 volt vcc to 1.2 volt. I don't know why its happening. Anyway, is...
This previous question about multiple advertisements seems to be related to softdevice 7. I was unable to get a similar example working in SD/SDK8
My end-goal is to add...
We are considering using Gazell for an outdoor application, i.e. lots of noise and disturbances, constantly changing environment, where the amount data being transferred is...
Hi everyone,
I have found your git "Ble Optiboot"( github.com/.../ble-optiboot) , and I have understood, it is usefull to load a binary into MCU flash, I was looking for...
I'll go ahead and describe what I need to do and see if anyone might have some place to start for me since I'm having a lot of trouble figuring out what I need.
I'm looking...
Hello ,
I'm designing an embedded system with one of your RF chips (NRF24L01+) and as far as I searched for the datasheet , It seems like NRF24L01+ doesn't have a hardware...
Hi,
This post is very old.
devzone.nordicsemi.com/.../
I have a nrf51822 chip and I'm using it as BLE and it exposes some service and characteristics and it is working...
The reverse task is easy: Central can read service 0x1800, attribute 0x2a00 from peripheral. Central can obtain peripheral name from advertising data...
But how peripheral...
I'm using sdk15.0.0 and device nrf52840
I have 5 services among them only 1 service is for notifications and remaining services for reading and writes functionality. ...
Hi,
I build an Xamarin bluetooth application and I needs Plugin BLE nuget package Service, Characteristic and Descriptor UUID numbers. My device is nRF52840. I would like...
Hello everyone,
I am using UART in my project to send data and receive data
the issue is while I am debugging it shows or indicating at NRF_BREAKPOINT_COND;
but led...
Hi everyone,
I am developing a custom PCB that will integrate the nRF52840 SOC. More specifically I will use the MDBT50Q-1MV2 module from Raytac that is approved by Nordic...
I am working on nrf51822 and SDKV10, Softdevice S110. Firmware has implemented whitelist features and enabled bonding.When i bonded the device using nrfConnect App and the...
Hello,
My home application requires standard Wifi 2.4/5Ghz and Bluetooth 5 protocols for communication. I see that nRF has a proprietary Wifi, what are the differences ...
Hi need to change configuration which uart is used when mcuboot is going to serial recovery mode. I would like to have this set for uart1 by adding: Then I put nrf91 in the...
Hi, our product is one set of transmitter/receivier based on nRF24 series. Recently, the number of failures of receivers increases quickly, and most of failures are shown...
Hi community !
I got a weird problem for me. I got a program (BLE Mesh) which i flash on two nRF52840 Dongles, and i got 2 differents behaviour
The first one can be provisioned...
I used nRF connect on iOS to get values from a device. I can see the characteristic property as indicate: when connected it displays the values I need.
1- Is there any way...
HI,
I purchased the nRF51822 Bluetooth Smart Beacon Kit ( I knew it's discontinued ) to perform a quick and simple POC (put my custom 31 bytes for the beacon to advertise...
Hi All.
I have an issue with my development kit. I was working with DFU so I flashed the secure_bootloader project in my nrf52 DK so it is working fine.
But after this...