Hello-
I'm working on our design for the nrf9160 and I've been trying to wrap my head around the FCC certification. I know that the nrf9160 is an FCC certified module and...
I was doing development on the development kit and I noticed that when flashing the device there is application core and modem core firmware that is flashed
I'm trying to...
Background
Our device uses the CONFIG_LTE_NETWORK_TIMEOUT option from LTE Link Control, which by default is set to 600 seconds (10 minutes). I haven’t found any specific...
Hello, as the title suggests, I have an issue when powering the nRF9151 DK with an external power supply. Normally, I power through USB, and it's fine. However, when I followed...
Hi all,
I am using and nrf9160, in particular a thingy91. It is running 1.3.7 firmware. I have the SLM sample loaded and can sent AT commands to the device using the nRF...
Hello,
We are working on Zephyr sample app Mesh on nRF52840dongle with nRF Mesh application.
After going through the documentation and few other Q&A on the portal, I was...
Hlo
I have designed a custom board based on nRF5340. Now I am trying to do flashing and RF testing of it through nRF5340 development board but can't even flash it because...
Hi,
We are using the Experimental Bootloader example from nordic SDK 10. The project is a good example on how to check for authenticity and integrity of the update package...
Hi.
I'm doing a project of wireless sensor network. It is a small network of less than 6 elements, so I'll use piconet. I have ble_app_hrs working perfectly. But only with...
Hello,
I'm working with a nrf51822, SoftDevice S120 v2.0 and SDK v9.0 platform.
Specifically using it a Central role to connect to a Blood Pressure peripheral.
When...
In section 7.5.2 of the nRF24L01 Datasheet it states:
PTX enters RX mode and waits a time period for an ACK packet each time a packet is transmitted.
During this...
Not really a question, but I found a potential issue with the Battery Service module in ble_bas_battery_level_update() . This is in both SDK v10 and SDK v12.
The problem...
Up to this, we've been prototyping with MDBT40 module in our prototypes. We want to move to a completely custom PCB using the nRF51822 SoC for a number of reasons (space and...
Hi,
I am using nRF51-DK with softdevice S130 and SDK 12.0. I am working on the BLE central role with ble_nus_c service. I am able to setup the multiple connection with...
Hello,
In the last month i bought the nr52-dk, my first two steps handling it were:
the getting started tutorial and some other tutorials to get the feeling of the...
I am doing some test with the Battery Service on SDK v10, and found out that if I have not enabled Notification on my phone, calling ble_bas_battery_level_update() returns...
Hello.
For routing purpose, I use GPIO pin for NFC for spi, driving a screen.
I start a screen integration with the with the spi peripheral example projet. Using the define...
I am using the nRF52 (SDK12.0.0) to create a very simple BLE application (maybe based on the BLE_APP_HRS example). The system will have a button, LED and interrupt pin from...
Hello,
we have successfully run Nordic chip together with iPhone and we are able to get notifications from iPhone to the embedded device using ANCS via Bluetooth LE.
...
I am using the nfr51 dk and a standalone nrf51822 based ble module for prototyping & testing purpose.I plan to make my own custom pcb for final production.In both the above...
