Hi We are working on setting up CI/CD pipelines for our nRF application. The application is set up as a stand-alone application with its own west workspace. It uses external...
Hi ,
1.In the example: In nRF5_SDK_17.1.0_ddde560_usbd_msc_1\components\libraries\block_dev\qspi\nrf_block_dev_qspi.c, I need to set the following 0xB7 bytes. How should...
Hi I'm testing the current consumption of the external qspi-flash on nrf5340dk [ MX25R6435F]. I have used ppk 2 to measure consumption with the dk and also have used a power...
Hi,
We are using nrf21540 in GPIO mode + mode pin ( and CONFIG_MPSL_FEM_NRF21540_RUNTIME_PA_GAIN_CONTROL) with an nrf52833.
We are developing under nrf connect sdk 3.0...
During the development of a Matter over Thread product, I encountered the following issue:
After adding two Matter over Thread devices (an OnOff Switch and an OnOff Light...
Hi Nordic Teams :
I would like to check the current consumption by BLE DTM.
1. Is the table measurement is from 3.0V input?
2. I find the condition in the datasheet...
Hello,
I cannot use the nRF Sniffer because it is always crashing. This is a confirmed bug in the Software and the OSX client written is working flawlessly.
I have experimented...
Hello,
I am newbie with KEIL/SEGGER, I have been following this tutorial to compile the example experimental_ble_app_blinky_pca10040_s132 for my nrf52 chip, the project...
Hello,
I am using sdk 12.2.2 and nrf51 dev kit. I am trying to upload ble_app_gls example code over the air to nrf51 dev kit. I can find only secure_dfu code in the sdk....
I am considering build some of my own shields to interface with the nRF52DK for the 832 and 840. I am curious how I should use header P5 with the shield detect pin. Should...
Hello,
I am trying to implement my custom service with NUS. I have gone through almost all the solutions presented on this forum.
Observations:
The board does...
Hi,
I need to be able to change the GAP parameters of my connection for only a short period of time to save battery life but have high throughput when I need it. My firmware...
Our workshop is using custom PCBs for other manufacturer's developer kits, and I'd like to do a similar shield for our nRF51-DK boards. Can anyone provide a KiCad project...
Hi all,
I took the example SPI program and I am trying to add UART code to it to debug the SPI transfers. Both examples are working well for me separately. I was able to...
I am working one one star network system with NRF24L01+. I got success with one pair (Single TX and Single RX) on communicating. But I could not get any positive result for...
Hi,
I'm working with an SPI FLASH chip that has a page size 256. I noticed that when I call nrf_drv_spi_transfer() , the rx length of 256 rolls over the uint8_t container...
Why the SPI clk doesn't work, i checked using an oscilloscope :/
I also don't get any SPI interrupt and no data change in the RX buffer although I have wired MISO and MOSI...
Hello,
I just encounter a compatibility issue between the two SDK (11 Vs 12).
So i have so product on the market base on SDK V.11.0.
I m developping an update based...
