Hi,
I recently found out about the Periodic interval feature on GRTC CC[0] and it seems like it would be quite useful for my application. Most of my code so far uses the...
Hi,
I have integrated Neuton’s “Transport Type Detection” pre-trained model into my firmware, running on a nRF52840dk. For collecting 9-axis IMU data, I’m using the ST X...
I'm trying to implement a fall detection feature on the headset side using the LSM6DSOX IMU sensor. The IMU is configured successfully, but the board halts after the INT1...
I have a ready hogp struct and I'm trying to subscribe to an input notification (I'm connecting to a bluetooth keyboard) and I'm getting error -22. Here's the callback in...
Hello,
I am trying to count pulses on nRF52840 DK's pin for measuring water flow with hall effect sensor. I tried to implement PPI + GPIOTE + TIMER in counter mode, but...
Hi, I am using nrf52840-based custom hardware and have an external flash connected on SPIM3. Till now I was working with my other peripheral connected on different buses and...
Hello Nordic Team
I am using SDK 3.0.1 with a nRF52DK to develop a firmware that can be switched from BLE mode to GAZELL mode and vice versa over a command sent via UART...
Good day All,
We are in the process off procuring a project using nRF52, and I need to find out some important things. Are there any costs in using any of the libraries...
I am using nrf52840 module(peripheral) for transmitting 10samples/10ms and central device as the same nrf52840 for receiving the samples. Although I receive the packets, there...
Hello,
I'm working on an application in which I have to dynamically switch between a TWI master peripheral and SPI master peripheral that use the same peripheral ID (our...
I have an NRF24LE1 transmitter using ESB. It is sending a static payload of 10 bytes every sec.
The other configurations on the transmitter are: RF channel:2, CRC: 1 byte...
Hi,
i'm wondering if there is any IC (for example nRF52832) that can reach a range up to 155 meters available within the Nordic semiconductor catalog ?
i know that the...
In nRF5 SDK 12.1.0 a bug was fixed in nrf_drv_wdt_init(). Watchdog timeout could not be larger than 131 seconds because of (x * 32768) multiplication before. This bug is again...
In the spec it says that the typical ramp up time is 140us (or 40us in fast mode). But there is no details on maximum or minimum. What is the true tolerance on this value...
We are building a simple project, let 51822 connect the mobile, once per second. We found that the Tx power of 51822 is getting weaker and weaker (view the voltage over a...
I have a nrf51 dongle and would like to use PWM on 3 pins.
Managed to get it working on pins 15 and 16, but somehow pins from 17 to 20 just don't work.
For example: I set...
Hi,
I have two nrf52840 boards and I am using the ble_app_att_mtu_throughput test app. The tests seem to be working OK, but I am not getting the throughput I was expecting...
When performing flash operations, i.e. via FDS or FSTORAGE, etc. - will GPIOTE events be captured and 'queued' until the CPU is no longer halted?
Said another way:
Can...
Hi ,all
I have a problem in my project .I want to use gzp preload ack feature .When the host receives datas ,I would use this function "void gzp_preload_ack(uint8_t* src...
Hi,
I've asked a few questions previously regarding programming of the nRF24L01/+ for simple data interchange between two devices, and my questions were answered -- many...
