Hi,
I use the nrf51422 chip.I want to know if the ANT establish link between chips,where can I get the matching configuration (like device type、channel ID).I mean is...
Is there a way to recieve more than one write callback for a given characteristic, per radio session? It seems like I can rx 1 time per attribute per radio session and tx...
If it can work with iOS blue setting will be better
I need some reference to dev hid device in IOS
but I can just find my device ,connect ok but not work.
I need to create timeout below 1ms. I would pretty much like to use timer for that because I do not want to hold the cpu inside cycle. For me it is not important the exactness...
Hi,
While testing the device firmware update through the nRFtoolbox android application, i get "device has no required service" error more frequently.
I use latest version...
I'm having some trouble successfully entering ON,IDLE mode. I have pared-down my application to do the following:
Initializes the app_timer using the scheduler:
...
I want to control GPIO toggle by PPI. Timer1 is in timer mode. CC[0] is 1000, and CC[1] is 8000.
I use compare[0] to toggle gpio18 by PPI. I also want to use compare[1] to...
Hallo all,
I have just noticed that nRF5 SDK 11.0.0 do not have support for S110 softdevice anymore.
I understand that from previous project that S130 is able to do similarly...
Hello,
I have made a custom board using nrf51822 QFAC that has an IMU on TWI interface. For programming I am using ST-LinkV2 and OpenOCD. The board is working just fine...
Having spent numerous hours/days on trying to get the SDK12 examples running on my nRF52DK board with MacOS SES3.12, I in result wrote a basic guideline that in the end makes...
Hi,
i search a FSK tranceiver with a ADC readout for a experiment.
I need the raw ADC ("audio") signal for a external signal processing.
Please help, most of the wireless...
I want to transfer application over the air(OTA) to NRF51822, with using nrf-toolbox in android mobile so please tell me step by step procedure. and how to setup nrfDK to...
hello every,do you have the same question?
i delete the bsp relevant document,then i find that when i disconnect it from APP,it delay to Generate disconnect events. i use...
I'm trying out 6lowpan examples in the IoT SDK, and while everything works,
if I want to disconnect by running:
echo "disconnect 00:50:49:71:3b:44 1" > /sys/kernel/debug...
I have compiled the following list of error that are given by BLE Stack from the ble_app_gls code.
I would like to know what action needs to be taken on reception of all...
Hi everybody!
I want to do a connection between two BLEnano, one is the mater and the second the slave.
I have programmed the two BLEnano using the Arduino IDE and libraries;...
Hello,
I was wondering what is the best option/way to merge two functionalities which are developed in different examples of the nRF52 sdk12.2.
For instance, I would...
hi,
my device is nrf52832
i run my spi sd card driver fine in debug mode, but when i download it ( F8 ), it can not work!
so my question is what is the difference...
Hi,
I need to monitor radio channels and find the best one (with lower background noise) to use.
Is there any way to measure radio signal level in a particular frequency...
My problem: The run of my 1. DFU - Implementation delivers an error code after executing the line "err_code = ble_dfu_init(&m_dfus, &dfus_init);". For my opinion this is caused...
