But now I have a new problem that is whenever I set " PWR_UP " bit in CONFIG register then it drop the 3.3 volt vcc to 1.2 volt. I don't know why its happening. Anyway, is...
This previous question about multiple advertisements seems to be related to softdevice 7. I was unable to get a similar example working in SD/SDK8
My end-goal is to add...
We are considering using Gazell for an outdoor application, i.e. lots of noise and disturbances, constantly changing environment, where the amount data being transferred is...
Hi everyone,
I have found your git "Ble Optiboot"( github.com/.../ble-optiboot) , and I have understood, it is usefull to load a binary into MCU flash, I was looking for...
I'll go ahead and describe what I need to do and see if anyone might have some place to start for me since I'm having a lot of trouble figuring out what I need.
I'm looking...
Hello ,
I'm designing an embedded system with one of your RF chips (NRF24L01+) and as far as I searched for the datasheet , It seems like NRF24L01+ doesn't have a hardware...
Hi,
This post is very old.
devzone.nordicsemi.com/.../
I have a nrf51822 chip and I'm using it as BLE and it exposes some service and characteristics and it is working...
Migration document is great - I'd be lost without it. I'm just trying to be sure I understand the two changes for "GATT Server Authorizable Write Commands" and "GATT Server...
Hi,
My S130 based BLE implementation, when scanning, seems to receive BLE advertisements out of order, when the traffic is high. I wonder why. Could it be so that the callback...
Hi,
I would like to misuse the SDK by creating an communications systems based on advertising. From several Q&A posts, e.g. this one ), I understand that the current S130...
Hi,
I am writing an application on top of NRF51, using a S130 Softdevice. I wonder about the concurrenceness (?) of the code I write, and especially if I need to use critical...
How do I make sure, the GATT server running on the BLE peripheral client connects only to a specific app based central/GATT client app, which has been authenticated via web...
Hi everybody!
I am working on ANCS and I found a problem that: At the first time I connect my Iphone to the dev kit, the pair request appeared on the Iphone. If I ignore...
Hi,
I have been having a lot of problems communicating with an Atmel SAM D09 as a slave, and an nrf51422 as a master.
I seem to have two problems, hopefully solving...
Hi all,
I design the kb based on the SDK6.1 and SD7.1 with 51822, and doing the PTS certification now, but meet some problem on TC_CON_BV_01_C, ATT Write error, such as...
the error messages show following:
compiling system_nrf52.c...
RTE\Device\nRF52832_xxAA\system_nrf52.c(92): error: #136: struct "" has no field "A0"
RF_TEMP->A0 = NRF_FICR...
Hi guys, I use old project try to build again in Keil when I installed nRF51_SDK_8.0.0. But I get the:
.\Objects\ble_knob_detection.axf:
Error: L6200E: Symbol
GPIOTE_IRQHandler...
Hi guys,
Has anyone encountered following warning message when using nRF51 SDK v8.1.0 or 9.0.0 and compiling project by GCC arm-none-eabi (I'm on V4.9 2015q2 which is the...
Hello,
I have a peripheral that manages several bonds to known centrals. Assume I want to pair with some fresh central, yet I need to do that within physical reach of another...
