Hello Team,
I am currently using the nRF54L15 DK with NCS version 2.9.0 for development and compiling code for the nRF54L10 board.
I am trying to implement FOTA updates...
Hi As part of attempting to write code for self testing I'm trying to measure the HFXO frequency using the LFRC (we don have an LFXO) I'm expecting that the measured HFXO...
Hi,
We're planning to design a custom board using the nRF9151 for LTE connectivity. We'd like to add basic BLE support, with the following constraints:
The BLE chip...
Hi,
I am trying to set up a project that continuously measures the pulse width of a signal that may or may not be present at a pin.
I want to use a Timer in capture...
hi
after success dfu operation the firmware start to run
then i am getting stuck write after err_code = sd_ble_gap_device_name_set(&sec_mode, new_name, DYNAMIC_NAME_LEN...
I've been following the information on the nRF54H20 with interest as it is most likely the natural candidate for upgrading our existing design. However, I have been waiting...
We are developing an application on nrf52840 and wanted to use M95P32 as external flash.
used below .overlay configuration to enable it on zephyr.
&mx25r64 {
compatible...
Hello Everyone,
I was taking a look at the PCB in Ditto . It uses an nRF51822 and supports firmware updates from their app which means they put a bootloader on it.
I've...
hello guys,
I'm working in a project & I'm debugging using nrf15822a development kit, I want to implement the DFU & security feature to have a secured link and to be able...
Hi guys..
I try to figure out how to connect nrf 51df , raspberry pi (ble enabled router), COAP client which is on the external network. Trying to figure out it, I found...
I noticed the following compile time issue in the SDK - both 10 and 11:
The file ./examples/ble_central/ble_app_hrs_c/main.c
needs:
#include "app_uart.h"
For...
Hi,
Could anyone give some advice how can I let 51822 works in RFID mode.
Can RFID work together with BLE? Or is there anoter HAL support like Softdevice? Where can...
Interrupt_Sleep.txt
Currently, I'm trying to use external interrupt that generated by ADXL345 to wake up the nrf51822 after sleep but not working as i want. Kindly check...
I'm had develloped some software and tested it on the nRF51-DK.
After that I made my own PCB design where only the nRF51422 is replaced by a nRF51822.
When I flash both...
I have a legacy RN42 BT2.1+EDR running in a system as the network master that I need to connect/pair with a nRF51422 BLE dev kit, and am having problems.
The BLE just doesn...
HI All,
I tried to migrate from nRF51_SDK_10.0.0_dc26b5e to nRF5_SDK_11.0.0-2.alpha_bc3f6a0
my migrated ble_stack_init:
static void ble_stack_init(void)
{
uint32_t...
I will try to use the s110 8.0.0
But I can not find the sdk installer from the website.
Three months ago, when I visited the website, there is a SDK 6.xx.xx Installer...
Hi.
I'm currently receiving advertisement packet from beacon scanner app. (nrf51822)
(ble_peripheral/experimental_ble_app_multiactivity_beacon/hrs_scanner)
I tried...
