Hello,
I'm here again because this time I need to autoconfigure (configuring from inside program, no use of any nrf app) heartbeat destination node and source node.
For...
We have developed an application which uses the nRF9160 together with the same GPS and Ethertronics/Kyocera/AVX antennas as that of the nRF9160-DK . For the LTE antenna, we...
We're trying to measure supply current used by the NRF9151 DK but have discovered that the current measurment connector (P22) only includes current supplied to VDD, and that...
Hi，
I am using nRF54L15-DK for Zigbee light_stwitch startup testing. After successfully connecting the development board to the Hub for the first time, I evaluated the time...
Hi
I have a code previously can be built in NCS 2.91:
However, when I use the new NCS 3.01, it can not be built, the error is:
Could you please help me figure out...
Hi,
I am trying to integrate the nRF5340 Audio application (CIS Unicast Server role with bidirectional streaming enabled) from NCS 2.9.0 into on my custom nRF5340 based...
nRF52840 NCS 3.0.1 RCP
I just installed the NCS 3.0.1 SDK. I am trying to set up a border router on a Raspberry Pi 4.
I followed these instructions on the Raspberry Pi...
Hi!
Can you please recommend a LDO IC for a USB/Li-polymer Battery power for the nRf51822 please? The LDO needs to drive the nRf51822 and a couple of sensors such as Gyro...
I'm trying to get the ble_app_hrs example working in Eclipse, but the stack pointer is not setup correctly. It's at the start of the RAM (0x20000000), and therefore it already...
I'm implementing an Android 4.3 app which uses an nRF51822 and the BLE proximity profile. I have the following as starting points for the app code:
The BLE sample...
I can't seem to find the required current of NVMC doing erase and write. The product spec has only timings but not more. Could someone from Nordic provide some figures? Experimental...
Hi,
I have a C# app connecting to 51822 devices, doing data/firmware download. When I try to send erase page command (before write), erase works, but there is a disconnect;...
Should we keep track of this by monitoring the write events or poll the gatts value via the softdevice?
It looks like it's faster (+shorter = less consumption) to monitor...
Over the past few months I have worked extensively on a few different projects that all utilize the nRF51422. In some recent debugging of GPIO issues (both relating to SENSE...
As the title says, I am wondering when the new SDK will be released to support the nRF51822 hardware revision. It looks like the latest (v4.4.1) doesn't have anything new...
the very similar issue
Friday, October 04 2013, 02:23
I have staerter kit + development kit. I have installed all required software and can't loat example code because...
I Every one !!! Thank for the possibility to participate in this forum.
I am trying to initialization configuration of my nRF24L01+ .
I am using CY8C3866AXI-040 from Cypress...
Hi, i'm experimenting RTC1 using the app_timer module (not using S110 soft device), and i find some problems onRTC prescaler. If i set values as stated in the datasheet, for...
Hi,
I am trying to run several applications sequentially on the nRF51822.
I have another microcontroller controlling the nRF51822 by SPI.
I init the stack, the services...
Hi, I'm just wondering if there's a reason that the example code is always initializing all structures through functions. Has it something to do with sleep mode and RAM retention...
Hello,
I have a couple of questions about sending multiple notifications:
I want to send multiple notifications (from same characteristic), is that allowed by...
