Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
I am working on code to setup a bond manager for ancs based off of the example, but have a fixed advertising and connection interval of 25ms. How does the bond manager and...
Hello,
We have experienced odd problem, we are not able to scroll up or down SDK documentation at these pages on Android devices. IPHONE browser Safari works ok. Any help...
A beginner's question.
I am using UART over BLE to send data out.
As codes below, ble_nus_string_send() works and continuously sending data out, with the Wireshark's...
I have some problem when I implemented 52832 dfu.
I implement it with sdk 11.0 and a third party core-board.Firstly,I program s132_nrf52_2.0.1 SoftDevice by nRFgo Studio...
Hello i have a system that which i get data from a ultrasonic sensor and send it to Arduino UNO and nrfConnect application via the RBL Shield ( nrf8001 ) so i want to do it...
I am trying the ANT-OTA DFU Update using an ANT Stick and the nr51422 pca 10028 board. I want to use another nrf51422 board to update the previous board. Is this possible...
Hi All,
I have a problem where I cannot seem to wake up my NRF52832 with a GPIO. I am first attempting this on my NRF52DK with an interrupt form an accelerometer.
I...
Hi,
I'm trying to build a piece of firmware for the nRF51 DK, using the mbed OS 5 platform, but I keep getting a linker error from 'ld', using the ARM GCC 4.9 tools from...
Hello,
I want to build a list of available BLE devices and show the device names to the user via a display (pretty normal BLE search).
The search shall be done for devices...
Hello Everyone,
How could I use the temperature from nrf_temp.h in the Eddystone (TLM) example?
Eddystone (TLM) example:
<nRF5_SDK_v11_0_0 folder>\examples\ble_peripheral...
I am seeing signs of the chip wanting to be debugged by Eclipse on my Mac. It really does. I can feel it.
Two things seem to be plaguing me:
90% of the time it...
Dear Nordic Team,
I am using nRF51422 development kit.
I tried Beacon app example code.It consume around 195uA. How to reduce the power consumption.
I am also checked...
hi, I'am working in a project. I start a watch dog in that project,but I need to stop the watch dog something.And I don't know how to stop, can anybody help me.
nRF51822 and a PC were connected, nRFgoStudio was started and nRF5x Programming of a device manager was opened, the following comment comes out, and nRF51822 device can't...
