Hi Nordic Team,
The atomic fifo implementation is based on armv7-M, right now I want to port it into cortex-A processor, I made some changes to get it compiled without...
Hi,
Kit:nrf5340
Can you please tell me if there is any example in nrf connect SDK v1.5.0 related to data transfer concepts.
Is ble controller will be enabled during...
I'm was testing the gsp sample in samples/nrf9160/gps. It runs fine on my nRF9160DK and reports NMEA messages. However, when i ran it on my custom board, it failed in setup_modem...
Hi,
I'm attempting to obtain sensor values for a project to be completed less than a week from now and I have not yet started programming so any help would be greatly appreciated...
Hi
I am using nrf52832,SDK version: SDK : RF5_SDK_17.0.2 .
USE CASE:We have two central and one peripheral.We need to control two central with one peripheral(REMOTE...
Hello,
I am facing an issue with SPI when the SoftDevice S132 is enabled and i cannot figure out what the problem is.
The following test works perfectly when SoftDevice...
Hello~
The environment： Chip is nrf52820，SDK version is 17.0.2，sd version is s112_7.2.0.
pic1:
Pic1 the APP code that I wrote for this problem. When I only burned...
Hello, I wanted to test the VS Code extension but it failed for the following use case...
In our company, we are building our product-related SDK that uses nRF Connect...
OS in development environment ：Windows10 HARD :(Taiyo Yuden)EBSHSN Series Evaluation Board : Central / Peripherals CPU :(Nordic) nRF52832 / ARMR Cortex-M4F 32 bit processor...
I'm attempting to write to flash memory on our custom board using the nRF52840 using the NVS library in Zephyr 1.5.0. I've ported over the example code from samples/subsys...
Hi everyone,
I try to get manufacturer data with central device.
The peripheral device is normally correctly configured for both advertisement report and scan response...
Hello.
Actually I have two qustions, but they are related with the same challenge.
So, I want to develop application using SDK (libararies and config), but starting from...
Dear ,
Thanks a lot for your time.
We currently have a project using nRF52840 dongle and nRF connect SDK, implementing FATFS and USB MSC SD card examples together.
The...
Hello
When I use ncs1.7.1 52840 + mcuboot + spi + external flash it works well, but when I update ncs to 1.8.0 I can't build it.
I also add CONFIG_MULTITHREADING =y in...
I'm trying to get my nRF9160DK board to connect to nRF Cloud, but I ran into some issues and it's not working. I've followed every step of the nRF9160DK Getting Started Guide...
I have configured the ADC on my nRF52832 to trigger a read based on a PPI timer. I am using EasyDMA to capture 75 samples via double buffering. My PPI timer is configured...
I am migrating my project to C++. Everything in the SDK works so far except NRF_BLE_GATT_DEF(). This returns the error C++ requires a type specifier for all declarations....
I'm using FDS on SDK16.0.0 to store some value, consisting of 12 int32_t values. They are stored correctly, except the first byte. Here is my code used to store :
It prints...
Hello,
is there any way to connect additional sensors using SPI or I2C to the thingy:91?
From the schematics I see test points on the PCB that allow access to the SPI...
