Hi, I have both the nRF8001 dev kit and the nRF51822 Eval Kit (EK). We are using the nRF8001 for most of our project with the BLE Arduino SDK. But I wanted to just load a...
Hi,
What is the suggested method to change a pending request, and make it earlier than previously requested, without closing and reopening the session?
For example,...
Hi,
I am using a custom pcb with a nRF51422 chip, and trying to setup ANT communication between 2 modules, but the sd_ant_channel_id_set call returns an invalid address...
Hi,
To use bidirectional continuous scanning mode in ANT, I have to transmit Extended Broadcast/Acknowledged/Burst messages using ANT Msgs 0x5D, 0x5E, and 0x5F (ANT Message...
We are preparing to get BT qualification for our product, developed with the 6 stack now, however want to update to 7 when it is finally released. A comment from the testing...
What is the best way to minimize transfer in progress errors when trying to send ANT messages? I am using the S310 stack on an nRF51422. I have a busy ANT channel that is...
I'm running into a weird timing issue with a nRF24L01+ which I'm not quite sure how to work around in the general case. The basic setup is two radios, A and B. Auto acknowledgement...
Hello,
I would like to implement a design using both the ESP32 Wi-Fi as well as the nRF52840 on the same PCB. As they both operate on the same 2.4GHz frequency and the antennas...
Hi,
I have used "write_handler(p_ble_evt->evt.gap_evt.conn_handle, p_rtc_service, p_evt_write->data[0]);" to send data to nrf52832 from mobile but iam able to send 1 byte...
Hello, I have 2 custom service running each with one characteristic. When data is written to the characteristic one (io_controle.c) the write event is triggered twice. The...
Hi,
did anybody find a suitable and cheap enclosure for the nRF51 Dongle? I want to use some of the dongles for initial tests before producing my own boards.
Thanks...
Hello, I have modified the example from the light switch on the mesh SDK and I can send and receive string messages, but the problem is that it doesn't work as expected, because...
I (unfortunately) had to make my own forks of Zephyr and NRF to get around a build issue, and decided to implement a west.yml manifest in my application repository. I made...
A makefile project using SDK 15.0.0 that compiled under GCC 7.2.1 no longer compiles under 7.3.1 with these errors:
../../../../../../external/segger_rtt/SEGGER_RTT_Syscalls_GCC...
Hi
I am trying to run the light_switch example, following the steps provided in this link . I have one Development board and 2 custom boards. It asks for Segger IDs for...
Section '5.2.1.1 Sleep' of the nRF9160 Production Specification v1.0 identifies SLEEP power with no RAM retention. My application will require partial RAM retention during...
Hi
I am trying to start development with Bluetooth Mesh. As per the documentation here , I have installed nRF Command Line Tools. While running the python script "quick_start_demo...
Hello All,
We have a custom board with nRF52840 and I believe, we have problem with the HFCLK.
We are trying to test our board with the ble_app_blinky example and it works...
I use Nordic 52832 as the master-slave machine with pairing and binding at the same time. I can get all paired peer_ids, but how do I know if this is a pairing binding when...
I am using nRf5 SDK v12.2.0 for nRF52832 based custom board.
Let me know, How can i build SDK example with Keil uVision ?
What should be pre-requirements for it ?
