Hi,
Recently I want to set up a dynamic network that with the node change this position ,the network will change dynamically.But there is the question,with the node's position...
Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
I am working on code to setup a bond manager for ancs based off of the example, but have a fixed advertising and connection interval of 25ms. How does the bond manager and...
Hi,
I have nRF51 Evaluation Board and I can program BT600 Module.
But I am planning for getting BM832. Need to know whether i can program the Module through nRF51 Evaluation...
I have two NRF52 based devices. One is a portable sensor tag and the other is a fixed base station, with an external memory IC and internet access through a modem. The base...
Hello,
When enabling the ADC in the nRF9160 and taking a sample, the power consumption increases with several mA.
How do I disable it, to save battery power when putting...
Hi,
I want to implement a such system that there are about 10 BLE devices running with zephyr os on nrf52832, and some of them act as Central role, and some of them act...
Hello everyone,
This question is aimed at both Nordic and everyday users of a forum. I am testing out NRF52832 devboards in a mesh configuration I can run examples from...
When I hit the app_error_fault_handler() , gdb doesn't have a stack trace anymore: Backtrace stopped: previous frame identical to this frame (corrupt stack?)
There used...
Hello
i have the following parts which i want to flash to the nrf52840 with nrfconnect.
Softdevice s140, open bootloader, own application.
If i flash all at once the...
Hi,
I am developing zigbee sensor systems with security "install codes".
I encountered strange thing.
SDK version : v3.0.0
problem : physical address and install...
Hi,
I have NINA B112 eval board with me ,can anyone help me in stetting up the board with example code , which SDK should i use for this ?
Can anyone also tell me which...
I have managed to upload data from nRF52832 using nRF9160. I upload the data as tempreture sensor (although they are just values in mV), and my interface at the nRF connect...
I have extended the Template app in nRF Toolbox. When my app runs in the background on an Android 8 (only) device and I try to connect to the peripheral, I get this error...
Dear support,
The build of the asset tracking application is not working
Below the copy and paste of SES buildlog
Building ‘zephyr/include/generated/driver-validation...
Dear Team,
could you please share some info on the Content of the nRF9160 Chip when it is shipped from Distributor? or a Sample?
What is the Content of it? is it empty...
