Hello：
Why Bluetooth Go to system-off mode, sd_power_ramon_set can not be stored. In D: \ RAM save nrf51_sdk_v5_2_0_39364 \ nrf51822 \ Board \ nrf6310 \ s110 \ ble_app_rscs...
Hi,
Recently I want to set up a dynamic network that with the node change this position ,the network will change dynamically.But there is the question,with the node's position...
Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
hello,I am testing twi scanner example of nrf52dk.I want to read slave address, the sda & scl pins are 26 & 27 respectively. I am connected PCA9536 module as slave & address...
I have developed the code to send the data of mpu6050 from ble peripheral to ble central. i can able to receive the accelerometer values at ble central.It works fine.
Now...
Hi,
I use the NRF-toolbox app's UART feature for connecting to nordic devices.
Android version is 4.4.4 and the device used is a Samsung device.
Everything was working...
modify ble_app_uart example。
I change the #define to another value：
But whether lightblue or nRF connect，It only change the advertisement's UUID.The Characteristic is...
hi,
im trying to implement a one shot timer and followed the tutorial here:
devzone.nordicsemi.com/.../
note that i adapted the code for a custom project (and a custom...
According to nRF52832 Product Specification v1.3, tPOR is written as follows.
Is the VDD rise time range from 0 V to 1.7 V or from 0 V to 3 V?
Please tell me the range...
Hello,
I'm trying to change advertisement packets, I found this link text
it says:
p_data Raw data to be placed in advertising packet. If NULL, no changes are made...
Hi, I'm trying to change ad packets in the blinky example. I want to be able to keep blinking but change the ad packs (don't know if this make sense, but main goal is to change...
I have created a build system that will install openmesh on simblee chips, and it appears to be mostly working. However, range is very poor, like max 2ft. I have tried adjusting...
Hi guys,
I am working with a central battery powered so, I am controlling the RF activity calling scan_start() or sd_ble_gap_scan_start() and disabling the RF activity...
Hello,
We are switching chips from the nrf51 to the nrf52832. I have a nrf52-DK board now. My Eclipse set up is still able to compile, run, and debug my nrf51 projects...
hi,
im a little lost with BLE at the moment. all i want to do is sending 3 bytes of data (sensor data) approximately 10 times (+- 5) a second (when the uC is not sleeping...
As a central, I am writing to a variable length characteristic, advertised by a service of my peripheral. In this case, I am sending 80 bytes of 0x01 as a test
uint8_t...
