Hi Nordic Team,
The atomic fifo implementation is based on armv7-M, right now I want to port it into cortex-A processor, I made some changes to get it compiled without...
Hi,
Kit:nrf5340
Can you please tell me if there is any example in nrf connect SDK v1.5.0 related to data transfer concepts.
Is ble controller will be enabled during...
I'm was testing the gsp sample in samples/nrf9160/gps. It runs fine on my nRF9160DK and reports NMEA messages. However, when i ran it on my custom board, it failed in setup_modem...
Hi,
I'm attempting to obtain sensor values for a project to be completed less than a week from now and I have not yet started programming so any help would be greatly appreciated...
Hi
I am using nrf52832,SDK version: SDK : RF5_SDK_17.0.2 .
USE CASE:We have two central and one peripheral.We need to control two central with one peripheral(REMOTE...
Hello,
I am facing an issue with SPI when the SoftDevice S132 is enabled and i cannot figure out what the problem is.
The following test works perfectly when SoftDevice...
I would like to use the direct test mode (DTM) to test my own hardware with Rohde & Schwartz CBT. I have managed to create a simple test case using nRF52 DK and the example...
Hi Nordic team,
I was using my PPK with a custom board I used in the past testing new features in software, the PPK with nRF Connect was measuring everything fine, since...
Hello,
Are there any documentation on the python API for the sniffer? e.g. Definition of parameters? For device list from scan, the output may look like:
BLE device...
Hi,
For a running project I would like to have a nRF52840 based mini dongle (Logitech Unifying formfactor).
I found some parties who sell nRF52840 dongles but thy...
Hi,
I have successfully detected my custom board (nrf52832 chip ) with nrf 52dk board and program it with blinky hex file given in SDK 15 version and works.
Now, i update...
Hi Guys
I got a nordic thingy:91 and just play a bit with it and the asset_tracker application. Everything is working and the thingy sends its data to the nrf cloud.
My...
Hello, I am creating a peripheral with a totally custom set of services and characteristics (it will only talk to our custom central device). I've adapted the examples and...
Hello, in my application (adapted from ble_app_uart peripheral example of SDK 16.0) I am starting advertising using
err_code = ble_advertising_start(&m_advertising, BLE_ADV_MODE_FAST...
Hi.
I'm working with both custom board based on nrf52840 and nrf52840-dk.
I just moved from the app_uart api to the abstract serial api.
I have noticed that when an...
Hello,
I am using nRF52840, SDK_16.0.0, SoftDevice S140 V7.0.1 and Segger for flashing the image. I am using ‘ble_app_beacon’.
1) ‘ble_app_beacon’ will only broadcast...
Hello Devzone:
Would I be correct if I assume enabling APPROTECT should prevent writes into UICR? - for other readers, NO, IT CANNOT PROTECT AGAINST SOFTWARE READS/WRITES...
I am in the process of adding central functionality to ble_app_buttonless_dfu on a PCA10056.
When I call nrf_ble_scan_filter_set, the resulting builds debugging is broken...
Hi, I want to use the ADC peripheral (SKD16) and I am looking for the most energy-efficient way of doing this. I design a prototype that will be based on nRF52840 IC and will...
For a temperature sensing application, I am trying to implement a TWI interface with a TMP116 temperature sensor. I am using Keil uVision 5 to write the program. I have been...
