Has anyone converted the app note AN34 DTM Python script to C# or C/C++ ?
The Python DTM script is works OK with the setup specified in the app note AN34 figure 2, which...
Hi,
I have a serious problem, when I use uart of NRF51822 QFAAC0 to receive data from another MCU, I found that it will lost one bit at same position everytime. my SDK is...
Hi,
I just started to interface the lcd display with nrf51822 evaluation board. The display i'm using is, spi compatible, 18" tft (160x130) from tiny lcd. I took spi master...
Hi,
We are using the nRF905 device in an application where it needs to switch between auto-retransmitting and sending single packets, due to it communicating with several...
This is not a real question for support. It's more a success story i'd like to share with you!
Our company develops firmware for various customers on a lot of different...
Hi all,
What is the maximum data rate for the nRF24AP2 when using the Synchronous serial interface?
I cann't see it in the datasheet.
Is there anyone can answer me...
Hi all,
I have sent an application ZIP OTA and performed DFU, the log:
...
<debug> app: All flash operations have completed.
<debug> app: Starting reset timer...
Hii,
i am using ble_app_hrs_c_pca10056_s140 and when connected to one particular device i am able to get battery level of advertiser but i what advertiser's device information...
Just like the title, I want to know what they are, because I recently in looking for nRF5 SDK for Mesh often see the nRF OpenMesh related information, so I think they are...
Hello,
I am trying to use ArrayList for EasyDMA along with PPI but I am not sure whether or not I am configuring it properly to be used with the SPI interface.
So far...
i am using ble_app_hrs_c_pca10056_s140 and when connected to one particular device i am able to get battery level of advertiser but i what advertiser's device information...
Hello experts,
I am getting into the word of Nordic and hence here is my first question. Kindly help.
Software version: SDK-14
Hardware revision: nRF52832 DK (PCA10040...
Hi,
The SoftDevice uses the GPIO pin and port abstraction to configure and control IO's. When developing in Thread, how does one access and control the nRF52840 GPIO's...
I call the following function to delete old FDS records before I write a new record. It works well if I have only one old record. But when there are multiple records, it stops...
When I use nrf_drv_gpiote driver by sdk8.1.0. with softDevice 8.
I got HardFault_Handler when run in
handler(pin,polarity); in the GPIOTE_IRQHandler
How to deal...
Hello,
I use stack S110 V7.1.0 on nRF51822 (the device is a remote with 4 buttons).
Currently the remote send advertising frame with the pressed button into the data,...
I am writing code for nrf51822 with softdevice and an accelerometer is connected to the nrf chip. The accelerometer provides interrupt to nrf chip over GPIOTE whenever there...
Hi Nordic,
I am trying to extend DFU feature to my beacon application. Please help me with how to go about it. I went through the given tutorials on DFU/OTA, but I haven...
Hello sir,
I have develop my BLE_UART code is working fine with nRF52832 DK board but when i flash into spark fun nRF52 is not working. But i able to flash into Spark fun...
