Hello Team,
Could you please share some sample application or procedure to handle power modes (Sleep, Deep Sleep, etc) of the nrf9160.
Please let me know.
Regards, ...
Hello,
I have tried twice to request for SUPL license for getting A-GPS working but it has been denied both of the times. I think first time it got denied due to mismatch...
Hi Nordic Team,
The atomic fifo implementation is based on armv7-M, right now I want to port it into cortex-A processor, I made some changes to get it compiled without...
Hi,
Kit:nrf5340
Can you please tell me if there is any example in nrf connect SDK v1.5.0 related to data transfer concepts.
Is ble controller will be enabled during...
I'm was testing the gsp sample in samples/nrf9160/gps. It runs fine on my nRF9160DK and reports NMEA messages. However, when i ran it on my custom board, it failed in setup_modem...
Hello,
I just started working with a couple of other people on firmware for a BT dongle.
The existing codebase/software build is based on Linux environment using command...
Currently with default thread network we are using channel number 16 ,Now if we want to change the channel to 25 ,I am using thread API otLinkSetChannel and to get channel...
Hi Everyone ,
I have setup an gpiote iinterrupt on a button on a custom PCB incorporating nrf52840. Whenever the interrupt arrives(button pressed) the bluetooth shall wake...
IDE : Segger Embedded Studio for ARM V4.12 , nRFgo studio
SDK : nRF5_SDK_15.2.0_9412b96 + SDK for Mesh3.1.0,
Softdevice : 6.1.1
Computer Platform : Windows 8 64 Bit...
Hi, I have been using MQTT_simple example and building my application on that. One thing I noticed is that power consumption is around 40mA. I would like to hit that 7uA or...
Hi,
I am using nrf52832_xxaa with SDK v11.0.I have the requirement to disable the debug at the start of the program.(Also to enable it if required in the future).
I use...
Hi All,
I would like to interface a sensor with nRF52840 DK via I2C. I am looked schematic of nRF52840 but I can't find anything about I2C pin.If anyone know the I2C pin...
Hi,
I aim to scan other beacons around me and get their RSSI values, then put this data in my advertisement. There will be many beacons so I need a big space for that data...
Hi, Guys,
I am trying to enable the readback protection for the code region 0 and code region 1, I know that the NRF_UICR->RBPCONF register is flash_backed, so I have to...
Hi,
I would like to generate messages based on whether the nrf52840 SWD is connected (through j-link and Segger Embedded Studio).
Is there a way to query this?
Thanks...
I am currently running ble_peripheral/ble_app_blinky using the nRF52840 Dongle and S140 nRF52 6.1.1. I have removed the lines for CONNECTED_LED and ADVERTISING_LED to get...
I am working on a BLE peripheral (nRF52840 & SDK 15.3), which uses the Peer Manager to handle encryption and bonding to an iOS central device.
Requirements call for the...
