Hello,
I have tried twice to request for SUPL license for getting A-GPS working but it has been denied both of the times. I think first time it got denied due to mismatch...
Hi Nordic Team,
The atomic fifo implementation is based on armv7-M, right now I want to port it into cortex-A processor, I made some changes to get it compiled without...
Hi,
Kit:nrf5340
Can you please tell me if there is any example in nrf connect SDK v1.5.0 related to data transfer concepts.
Is ble controller will be enabled during...
I'm was testing the gsp sample in samples/nrf9160/gps. It runs fine on my nRF9160DK and reports NMEA messages. However, when i ran it on my custom board, it failed in setup_modem...
Hi,
I'm attempting to obtain sensor values for a project to be completed less than a week from now and I have not yet started programming so any help would be greatly appreciated...
Hi
I am using nrf52832,SDK version: SDK : RF5_SDK_17.0.2 .
USE CASE:We have two central and one peripheral.We need to control two central with one peripheral(REMOTE...
Hi,
I am interfacing a TI TM4C123 microcontroller to the AddiCore nRF24L01+ Transceiver Module. I can consistently transmit and receive data with the microcontroller/nRF24L01...
Hi,
We are using nRF51822 in our custom board.
nRF51822 is interfaced with a MCU using UART.
We want to load firmware image in MCU which will then flash nRF51822...
Hi,
I have a nRF51822 Development Kit and a nRF51822 Bluetooth Smart Beacon Kit. I want to run on the nRF51822 Smart Beacon Kit the nRF-Sniffer (v1.0.1) application. The...
how i used central send data to peripheral.
one broad use S120and other broad use S110.Now i see explame is nrf51822\Board\nrf6310\s120\experimental\ble_app_hrs_c..have another...
In ble events handler after connecting to peripheral device i handle BLE_GAP_EVT_CONNECTED event and try to identity connected device:
case BLE_GAP_EVT_CONNECTED:
{
...
Use "nrfjprog.exe --eraseall --programs s110_nrf51822_7.0.0_softdevice.hex --program app.hex bootloader.hex --verify --reset" to flash my device, return a error "write_and_verify_hex_file...
Moving from SDK version 5.1 to 6.0, the buttons on my PCA20006 beacons no longer works as expected. When I press a button, it seems to register the release of a button incorrectly...
As I've seen many others have done, I bought the nRF518822 Development Kit not seeing that I needed the $400 nRFgo motherboard.
Searching around reveals that shouldn't...
I am trying to get the Arduino DUE up and running with the Redbear v2 BLE shield, and SDK 0.9.3.
It was a pretty trivial operation with Arduino YUN, but I not so much for...
Hi Nordic-Team,
I've spent a while trying to figure this out but I couldn't. I need your help.
I want to load the S310 softdevice to the nRF51422 chip + the blinky example...
Hi,
I am using the ANCS experimental library and am experiencing a very strange bug.
I am requesting to attributes: APP ID and Title whenever I get a notification source...
Hello,
i have some trubble with my current power consumption. I have already read other user question and solutions but nothing works for me. To reduce the power consumption...
I have built and installed bluez 5.21 on ubuntu 14.04 witout problem (see for example this recipe ).
My nrf51822 EK dongle PC10000 is not recognized by hcitool:
hcitool...
