Hi,
Kit:nrf5340
Can you please tell me if there is any example in nrf connect SDK v1.5.0 related to data transfer concepts.
Is ble controller will be enabled during...
I'm was testing the gsp sample in samples/nrf9160/gps. It runs fine on my nRF9160DK and reports NMEA messages. However, when i ran it on my custom board, it failed in setup_modem...
Hi,
I'm attempting to obtain sensor values for a project to be completed less than a week from now and I have not yet started programming so any help would be greatly appreciated...
Hi
I am using nrf52832,SDK version: SDK : RF5_SDK_17.0.2 .
USE CASE:We have two central and one peripheral.We need to control two central with one peripheral(REMOTE...
Hello,
I am facing an issue with SPI when the SoftDevice S132 is enabled and i cannot figure out what the problem is.
The following test works perfectly when SoftDevice...
Hello!
So I can connect, disconnect and write to my applications characteristics via a PyQt5 GUI I threw together. On the python backend, I use Bleak to
search for devices...
I'm using nrf52832 and building projects on it with the help of sdk 14 and sdk 11 for BLE. Now when I load my code for example the BLE HRS it loads properly with no error...
Hello,
I've upgraded my machine to Windows 10. I can't get Master control panel to work. I keep getting the error message:
No response from master emulator
...
Hi, I have a general question for BLE advertising, if several BLE peripherals broadcast simultaneousl(the advertising packets contain information the peripherals want to send...
1、how long will it take for me to cache?
Once I call sd_ble_gatts_hvx, assuming tx_queue is large enough, how long can I cache data to softdeivce?
For example, I called...
Hey, I'm just starting to develop an ANT device on the nRF52 devkit and am trying to modify the provided example to gain an understanding of the functionality.
What I have...
Hello,
I'm designing a board in which cost is a very important factor. I don't need a lot of the GPIO pins of the nrf52840. Are there any 2 layer reference designs available...
Hello All,
I have the following queries on low power consumption mode,
To update you on power saving tests that we performed at our end, here is our observations:
...
Hi all,
We need to develop a communication channel between 2 Controllers
One is Master controller and another is Slave controller
Master controller will send Data...
I'm developing a central providing NUS client service to multiple concurrent peripherals.
I use nRF52832 DK and SDK14.0, s132_nrf52_5.0.0.
I Want that NUS central can...
Hi,
I am working on another project.
I want to make BLE and USB BULK communication operate at the same time.
My development environment is Keil,
It uses nRF52840 and...
According to the point above
link text
i bought the thingy but i did'nt think about the jlink ..
you can add me to the advent calendar ;-> for a nRF52 DK because...
I understand that the connection parameters viz. connection interval, connection supervision timeout and slave latency are negotiated between the BLE Central and BLE Peripheral...
