I want to verify the 4Mbps transmission mode of the nRF54L15 series through ESB samples.But the highest value measured so far is 2.34Mbps, which is much lower than 4Mbps....
Hello,
I am currently using nordic connect sdk version v3.0.2 which seems to be the latest release on github. I am using https client example. As per the requirements...
Hi, nordic team
There is an issuse happened in my custom board with nrf52833,programming in ncs v2.9.0.
peripheral side is programmed base on peripheral_hid_keyboard and...
Hi all,
We are currently developing a modem application for use with a Linux host, based on a nRF9161 using nRF SDK 3.0.0 and toolcahin 3.0.1
When compiling the Serial...
Hi,
I'm using nRF SDK 16 for my application on the nRF52840 custome board. When I set both parameters (i.e., support for coded PHY and 1M PHY ) in the scan initialization...
Hi,
I made a custom board with nRF54L15. I do not have a spectrum analyzer, so I cannot tune how much power goes to the antenna or how much is radiated. So, I started ADV...
Hi,
I am currently working on a prototype with Silicon Labs Thunderboard sense. I am looking for a replacement product that has NRF BLE module. All I need is a BLE module...
Does the S110 v7.0.0.3-alpha DFU bootloader support nRF51822XXAB (128k) part?
I'm trying to flash the DFU bootloader on my custom PCB that contains a nRF51822XXAB part...
Hello
I have an application to process advertising report even if it is duplicated.
Is there any way to control whether the soft deice shall filter
duplicate advertising...
Hello,
I am using the example "ble_app_beacon", I have compiled and tested (all works well).
I am wanting to add more data to the scan response by passing more data to...
I'd like to run a softdevice application with OTA support on a RIGADO BMD-200 Evaluation board . I've successfully flashed the softdevice, the app, and the rigado bootloader...
I have a simple application which pretty much consists of the following main function:
int main(void)
{
SOFTDEVICE_HANDLER_INIT(&clock_lf_cfg, NULL);
ble_enable_params_t...
Hi,
We're working on BLE communication between iOS and 51822 and found a data reliability issue. We have a custom characteristics that iOS read 60 bytes data from 51822...
Hi,
I have made some changes with how we update tick timer inside FreeRTOS and the results are promising
.
The improvement is
RTOS tick will auto correct if masked...
I went through a similar post for nrf51 which explains the numbers pretty well ( devzone.nordicsemi.com/.../) . I wanted to know what the values are for nrf52. The internal...
We have a nrf51822 device that has to send 6 bytes back to back at 12K8 and 6-18 bytes at 38K4 in the future.
The bytes are in an array and do not need to be generated...
Hi experts,
I have just tried lbs example. I saw in the ble_lbs_c.h, the base uuid and service uuid are defined for the peripheral peers who are going to be connected....
I'm developing with nRF52, SDK 12.2 and softdevice s132 3.0.0 . I modified the saadc_ble code from github which uses SDK 11.0. It seemed to work fine. But disconnection happens...
Hi,
I adapted the ble_app_multilink example to continuously scanning for ibeacons and collecting rssi data.
Data are then sent via UART to a microcontroller which provides...
