Hi, is there an available developer in my tri-state area of Minnesota, N. Dakota, or S. Dakota? Please call me if you are available for a project for hire. The developer should...
I'm trying to design a very low power sensor that takes readings using ADC and SPI 200 times a second. I'm a bit worried by the current EasyDMA uses (1.1mA). As far as I can...
Hi, I am working on a project where I want to make one nrf51288 chip as central hub and connect that to a android phone and other salve nrf51288 .
idea similar to this: ...
Hi,
I have a code programming the nRF51422 development board to write to a Sharp Memory 96x96 pixel LCD screen using SPI.
Currently the code writes two numbers and a...
I've modified the ble_app_uart example by adding GPIOTE so that the transmitter sends a character to the receiver when a GPIO pin is toggled. This part is working well.
...
Hi,
I am working on my hardware product having nRF-51422 chipset. I just came to know from forum post that
nRF-52 chips will get arduino IDE support as standalone. I want...
Hi Everyone! I'm developing a program for NRF52820 that reads the tx power & rssi and makes the calculation for testing different devices, and I've faced some problems while...
Hello Nordic Semi team,
I am building two BLE product. One acts a peripheral and has server capability. Other is central with client capability.
I am trying to understand...
Currently we are integrating the serial and BLE DFU into a single binary executable. The project enables the logging (NRF_LOG_ENABLED = 1) and we use RTT as backend.
When...
i am using VS code, nrf Connect SDK version 1.7.0, (2) nrf 5340 DK boards. Running the CLI example.
uart:~$ ot diag start
failed
error 13 invalid state
uart:~$ ot...
I'm just starting to make a project using SDK 17.1, which is loosely based on a working, mature project based on SDK 15.2 and I'm hitting a bunch of issues. My path here is...
I want to implement an interrupt using TIMER2, but it stops at Dummy_Handler instead of going to TIMER2_IRQHandler.
Is it due to the fact that I have not defined TIMER2_IRQHandler...
This is a pretty top level description of the problem. I've not dug very deep, but what I've observed is that when deployed against an AWS instance set up per the instructions...
Hi, 1-I have successfully developed an app ...\ nRF5SDK17009d13099\nRF5_SDK_17.0.0_9d13099\examples\ble_peripheral\ble_app_template. 2-I have set a UART example to send data...
I need to implement a mouse and keyboard (combo) HOG device. There are mouse and keyboard samples, but may I integrate them in just one?
Is there any samplecode?
I have...
To whom it may concern:
We have a product in production based on the nrf52810 and SD 112 ver 6.1.1, developed with SDK 15.3. Due to our manufacturer having nRF52810 availability...
Hello,
I've been trying to access the nRF52840 dongle through the pc-ble-driver-py library. However, I can't get the Nordic examples to run. Here's what I did so far:...
I want to send my sensor data from one node to another node using BLE mesh. my data is at about 128 bytes I am trying to create a custom model but it's hard to know how to...
Hello, I am trying to advertise twice in my project with different gap_params.
First, I have started advertising with the following conn_params (shown below)
#define MIN_CONN_INTERVAL_ADV...
In a old post https://devzone.nordicsemi.com/f/nordic-q-a/58034/uart-communication-between-nrf52840-and-nrf9160-on-nrf9160-dk This question was already answered but this solution...
