Hi, is there an available developer in my tri-state area of Minnesota, N. Dakota, or S. Dakota? Please call me if you are available for a project for hire. The developer should...
I'm trying to design a very low power sensor that takes readings using ADC and SPI 200 times a second. I'm a bit worried by the current EasyDMA uses (1.1mA). As far as I can...
Hi, I am working on a project where I want to make one nrf51288 chip as central hub and connect that to a android phone and other salve nrf51288 .
idea similar to this: ...
Hi,
I have a code programming the nRF51422 development board to write to a Sharp Memory 96x96 pixel LCD screen using SPI.
Currently the code writes two numbers and a...
I've modified the ble_app_uart example by adding GPIOTE so that the transmitter sends a character to the receiver when a GPIO pin is toggled. This part is working well.
...
Hi,
I am working on my hardware product having nRF-51422 chipset. I just came to know from forum post that
nRF-52 chips will get arduino IDE support as standalone. I want...
Hi!
I've been using PCA10028 for a long time and I had some bricking issues but I've managed to un-brick it with "nrfjprog --recover" and everything would work again. ...
How can I get the lis2dh12 accelerometer speed at 1.344 kHz as mentioned in the datasheet from thingy52?
I have configured the registers as per datasheet of the accelerator...
I tried running the official ranging example with nrf5340dk.
Bluetooth: nRF Distance Measurement with Bluetooth LE discovery
Usage
This example can obtain distance test...
Hello,
I am working on the Raytac MDBT50Q-RX dongle which has the nrf52840 chip embedded. I am having issues programming it using the debug pins on the module, using the...
hi
board : nrf52840dk
sdk : nrf connect sdk v2.6.1
example: matter light bulb
problem:
I want to add another set of PWM to the sample code. How should I configure...
Hi,
I'm trying to implement the Current Time Service example in the SDK.
I downloaded the nRF Connect Desktop App for Windows.
I want to clarify how the example works...
Dear Nordic support team,
We are currently using a nRF52840 µC with NVS V.2.6.1 and sometimes the Android device acting as central, is unable to establish a BLE connection...
Hello,
I am in the process of adding LPN nodes to my network, Unfortunately I am getting a lot of "Ignoring old SeqAuth" Warnings on the friend side and looking at the friendship...
Hello,
I am working with the nRF7002DK board for the development. My BLE peripheral device is taking time to connect with the application, and sometimes it doesn't connect...
Is there any update plan for the ble sniffer firmware after 4.1.1
The 4.1.1 version currently has bugs in the sniffed coded phy. Please refer to devzone.nordicsemi.com...
Hello Nordic Team,
I'm building an application off of the Thingy53, taking advantage of the NRF7002EB as well as an additional Sparkfun i2c based alphanumeric display...
Hello Developers,
I am k.hemasundar and i am working on the nRF52833 QAAA0 micro controller with segger embedded studio IDE. I have used nRF SDK of version 17.1.0 and 16...
Hi Devzone,
I am facing an issue on my nrf52840-based custom board when I try to set up the USB mass storage class on an external NOR Flash as well as having MCUBoot enabled...
Hey there, Dev team!
I was wondering if you could help me out with using the "peripheral_cts_client" sample (struct bt_cts_current_time *current_time) to synchronize a timestamp...
