here I have a very strange problem. I m trying to send the data(1 byte) from slave to master,and I have to use the multilink demo because I will have 2 slave devices.
The...
I'd like to erase all the pages managed by FDS as part of a "Hard Reset" operation. fds.c has a hint of a "FRESH_INSTALL" directive (part of an enum defined in fds_internal_defs...
nrf51822
SDK v10
SD S110 v8
hello!
My pj is about ANCS+nus+hid mouse sevices.
If my borad had bonded with an iPhone,then download new hex from mdk ,and run.
...
Hello.
I would like to develop FW for the nRF52832, using Eclipse IDE + ARM GCC + Segger JLink OB.
I've seen on the segger webpage that the nRF52832 is a Cortex M4 processor...
When using app_timer through scheduler, a break and go will overflow the event queue if a timer is a repeat timer. The effect is that it's not possible to debug.
To work...
I need to be able to actively set the value being incremented in the Timer2 register on the nrf52 (what I believe would be it's main register). It seems that this might be...
The errata for the nRF52 indicates higher consumption in managing timers and GPIOTE. Does the BSP for SDK11 follow recommended practice to deal with these errata can I ask...
Hello,
We are facing some problem in getting output in NRF52840-QIAA-R. In our project we used pins of port-0 as SPI interface as bellow:
P0.05/AIN3 pin as CS
P0.06...
Hi, I'm assuming my node will have a lot of subcribe addresses, so I try changing the value DSM_NONVIRTUAL_ADDR_MAX. When I change the value of 150, there is no error, but...
hi,
nRF6939 live cd v5.4 not download.
https://www.nordicsemi.com/Software-and-Tools/Reference-Designs/nRFready-Smart-Remote-3-for-nRF52-Series/Download#infotabs
I...
All examples included in nrf52SDK 15.2.0 when running on Fanstel USB840F which has a nrf52840 chip, using Segger Embedded Studio and one of PCA10056 or PCA10059.
Using nrf52DK...
Hi,
I want to send a 2 digit number from one avr microcontroller to another one (to be specific from atmega16 to another atmega16 avr) using nrf24l01+ .
What I have here...
Hi, we are trying to work with nRF52840. We have a problem that our hardware goes into continuous reboot mode when we disconnect the JLINK debugger. The disconnect can be...
Hi，
I'm doing a rssi detect test based on nordic mesh sdk 2.2, it runs well when connect to a computer running SES by j-link, but almost don't work when running on board...
Greetings
Newbie question:
Im new to this BLE and RF world, and i'm trying to read all the info i can before buy the nRF52 DK when it got the IC without all the "erratas...
Hallo
Im using the example of nRF5_SDK_12.3.0_02\nRF5_SDK_12.3.0_d7731ad\examples\peripheral\uart
to setup a uart that includes rx as well as tx,
I am running the...
Hello everyone, I'm new with Nordic devices.
Actually wanted to get services correspondant to I2C slave addresses and registers.
I was thinking about using the SDK template...
i am using nrf52832 in sdk11. I am interfacing motion sensor and spi flash memory. Both motion sensor and spi flash shares spi lines and having different chip select pin....
