Hi, is there an available developer in my tri-state area of Minnesota, N. Dakota, or S. Dakota? Please call me if you are available for a project for hire. The developer should...
I'm trying to design a very low power sensor that takes readings using ADC and SPI 200 times a second. I'm a bit worried by the current EasyDMA uses (1.1mA). As far as I can...
Hi, I am working on a project where I want to make one nrf51288 chip as central hub and connect that to a android phone and other salve nrf51288 .
idea similar to this: ...
Hi,
I have a code programming the nRF51422 development board to write to a Sharp Memory 96x96 pixel LCD screen using SPI.
Currently the code writes two numbers and a...
I've modified the ble_app_uart example by adding GPIOTE so that the transmitter sends a character to the receiver when a GPIO pin is toggled. This part is working well.
...
Hi,
I am working on my hardware product having nRF-51422 chipset. I just came to know from forum post that
nRF-52 chips will get arduino IDE support as standalone. I want...
Hi,
I'm modifying files in the NRF5_SDK_14.2 distribution and it is not clear to me which ones are part of the core SoftDevice libraries (and I, therefore, should not change...
(I know it has been asked before, but I thought I'd check in again..)
Has anyone had any success implementing the Dallas one-wire protocol on the NRF51822 - in particular...
Hello,
I imagine this is a pretty common and basic question but I couldn't find anything online.
Since the nRF52xxx chips are single-band 2.4GHz (and possibly sub-GHz...
I'm having trouble writing to a gatt characteristic using the python bindings for pc-ble-driver
Service discovery works fine, I managed to connect to a BLE server and reading...
I have a device that I need to control, that needs 2 different square wave signals of different frequencies (although they may be multiples of each other), one at around 4...
Hi all. I try to run capacitive sensor example on nRF52832 with my hand made capacitive sensor which I made according to this tutorial devzone.nordicsemi.com/.../.I connected...
Hello,
When i execute a function that uses TWI from a timer handler the NRF gets stuck.
I assumed that this issue occurs because of interrupt priority so i gave the TWI...
after connecting and disconnecting advertisment not stopping when i try to stop it ( sdk 11). Without establishing connection i am able to stop it. Nrf51822
Hello
I am trying to create secure connection between peripheral device and mobile app & central device.
I created my own custom service and want to make them secure...
Hello,
My goal at the moment is to be able to configure my peer device which utilize ble_app_uart example so it would connect only to a specific master device e.g. android...
I am using BLEPeripheral and MySensors libraries and nRF51822 device(client side).
I want to change functionality, if I press key of nRF51822 device it should start to advertise...
I have a PCA10040 working with the mesh sdk.v1.0.0 serial example. I can do an Echo via the Python interactive_syaci and get a back a response. I have seen the documentation...
Hi Nordic
I am running ble and ANT + bsc code on our custom board. However, since the sd_softdevice_enable function does not return, I asked the question once. devzone.nordicsemi...
