Hi, is there an available developer in my tri-state area of Minnesota, N. Dakota, or S. Dakota? Please call me if you are available for a project for hire. The developer should...
I'm trying to design a very low power sensor that takes readings using ADC and SPI 200 times a second. I'm a bit worried by the current EasyDMA uses (1.1mA). As far as I can...
Hi, I am working on a project where I want to make one nrf51288 chip as central hub and connect that to a android phone and other salve nrf51288 .
idea similar to this: ...
Hi,
I have a code programming the nRF51422 development board to write to a Sharp Memory 96x96 pixel LCD screen using SPI.
Currently the code writes two numbers and a...
I've modified the ble_app_uart example by adding GPIOTE so that the transmitter sends a character to the receiver when a GPIO pin is toggled. This part is working well.
...
Hi,
I am working on my hardware product having nRF-51422 chipset. I just came to know from forum post that
nRF-52 chips will get arduino IDE support as standalone. I want...
Hello,
I imagine this is a pretty common and basic question but I couldn't find anything online.
Since the nRF52xxx chips are single-band 2.4GHz (and possibly sub-GHz...
I'm having trouble writing to a gatt characteristic using the python bindings for pc-ble-driver
Service discovery works fine, I managed to connect to a BLE server and reading...
I have a device that I need to control, that needs 2 different square wave signals of different frequencies (although they may be multiples of each other), one at around 4...
Hi all. I try to run capacitive sensor example on nRF52832 with my hand made capacitive sensor which I made according to this tutorial devzone.nordicsemi.com/.../.I connected...
Hello,
When i execute a function that uses TWI from a timer handler the NRF gets stuck.
I assumed that this issue occurs because of interrupt priority so i gave the TWI...
after connecting and disconnecting advertisment not stopping when i try to stop it ( sdk 11). Without establishing connection i am able to stop it. Nrf51822
Hello
I am trying to create secure connection between peripheral device and mobile app & central device.
I created my own custom service and want to make them secure...
Hello,
My goal at the moment is to be able to configure my peer device which utilize ble_app_uart example so it would connect only to a specific master device e.g. android...
I am using BLEPeripheral and MySensors libraries and nRF51822 device(client side).
I want to change functionality, if I press key of nRF51822 device it should start to advertise...
I have a PCA10040 working with the mesh sdk.v1.0.0 serial example. I can do an Echo via the Python interactive_syaci and get a back a response. I have seen the documentation...
Hi Nordic
I am running ble and ANT + bsc code on our custom board. However, since the sd_softdevice_enable function does not return, I asked the question once. devzone.nordicsemi...
hi i am using nrf52832 soc with sdk14.2.0 ble_central_multi-link example with soft-device s132v5.0
i want to know that is that any way to set connection handle number can...
hi,
i am using nrf52832 mcu with sdk 14.2.0 and with softdevice s132v5.0.0 with ble_app_multilink_central example to connect with nordic thingy 52 as ble peripheral to...
Hi,
I noticed you have added C13 and C14 (12pF) caps. However, they are not visible on Infocenter's reference circuitry. What are these caps for and why they should be...
