I'm still on stack 8.0.0 so it might have been fixed since. I have noticed that if the other side de-asserts CTS the Nordic code will leave the TX asserted in a Break condition...
Hello,
I'd like to ask what is the data rate when using BLE OpenMesh network and how much it depends on network architecture.
I'm considering using it in a network consisting...
Hello Nordic Community,
I need to know how to import my PCB design from Eagle to CST Studio to simulate it and I need to know if the simulation step will be useful to enhance...
Hi.
I'm trying to get Apple notifications to nrf52. And specifically to listen both regular ANS (for android) and ANCS (for iOS) events depending what sort of phone is...
I am trying to find out the part number of the antenna (I assume it is a PCB antenna) used in the nRF51 DK ( www.nordicsemi.com/.../nRF51-DK) . I found a lot of similar questions...
Hi.
I am using the NRF52 Development board, on Keil uVision, to implement a C program that uses Dynamic Structs. The Structs re-size themselves ( by increasing their capacity...
Hello,
I have an NRF51822 (redbealab ble nano) that I would like to use to count pulses in very low power mode.
Pulses are asynchronous
The rate of pulses can...
Hi,
I am looking for a sample programs for my use case, wherein :
1. I have to encrypt & store the DFU image which is present in secondary partition.
2. Decrypt the...
Hi,
I am trying to mount Fat FS using pm_static.yml instead of devicetree overlay fixed partition. I can generate a memory report, but when I try to mount file system I...
Hello All,
I have a very strange problem and i can not found any solution.
I have NRF52833DK and NRF52840DK where mi code is working perfectly. Compiled with OTA is ok...
According to the docs, when CEDRXS=3 is sent to the 9160, the modem disables eDRX and the unsolicited response code. However, this means there is no response code to listen...
Hello,
We found a problem with a device in mass production: nPM1100 doesnt start charging a deeply discharged battery.
Here is detailed information. This device was kept...
I downloaded the an saadc example here and tried to alter it to use logging as usually in Zephyr. But when printing to the console it does nothing. However, printf works fine...
Error when executing ble_nus_c_string_send
I am trying to achieve data transmission by connecting two nRF52840s to each other through an NUS.
I scan for advertisements...
Hi all, I have one program that starts and sets up a commissioner and another that starts a joiner and tries to join the commissioner's network. However, after starting the...
Hi
I'm currently using power configuration example nr. 4 for my custom board with nRF52840. Can I use external DCDC for powering my other components on the board (SPI and...
In the datasheet of the nrf52840dk board, for the port P4, there are freely available pins p0.26 and p0.27. If I use those two pins in the overlay file, I am getting "Pin...
Hi there!
I'm trying to make an SH1106 screen working with my Zephyr 3.7.0 project using an nRF52DK (nrf52832-based one). My project is straightforward:
proj.conf
...
