Hello Nordic Community,
I need to know how to import my PCB design from Eagle to CST Studio to simulate it and I need to know if the simulation step will be useful to enhance...
Hi.
I'm trying to get Apple notifications to nrf52. And specifically to listen both regular ANS (for android) and ANCS (for iOS) events depending what sort of phone is...
I am trying to find out the part number of the antenna (I assume it is a PCB antenna) used in the nRF51 DK ( www.nordicsemi.com/.../nRF51-DK) . I found a lot of similar questions...
Hi.
I am using the NRF52 Development board, on Keil uVision, to implement a C program that uses Dynamic Structs. The Structs re-size themselves ( by increasing their capacity...
Hello,
I have an NRF51822 (redbealab ble nano) that I would like to use to count pulses in very low power mode.
Pulses are asynchronous
The rate of pulses can...
Hi
I'm attempting to read a PT-100 sensor value that is part of a voltage divider using a nRF52.
Both the reference resistor and the PT-100 is sampled while the voltage...
Hi
I have been searching the forums, but were not able to find an answer to my question.
I'm trying to sample 4 analog inputs on the nRF51-DK using the ADC hal. (SDK10...
I found half of the information I was looking for (minimum voltages) from: https://devzone.nordicsemi.com/f/nordic-q-a/47546/nrf9160-enable-pin-voltage-specification W hat...
Env: SES, nrf52 DK, Linux
Hi
I need to define a buffer (array of structure) in order to buffer readings. If i have more RAM I should create a bigger buffer if I have...
We're using the nRF52832 as a peripheral and server. A central and client (tablet) connects to the nRF52832.
Yesterday I noticed that sometimes the tablet will try to perform...
Hello,
I am using nRF52832 DK PCA10040 v1.2.4, SDK_15.3.0, S132 SoftDevice and Segger for flashing the image. I am using ‘ble_app_blinky’.
What for this macro HWFC...
Hi, I'm looking for a PCB antenna design for nRF52832 based on 0.8 mm thickness four or two layers stack up .
I found some examples but based on pbc of different thickness...
Good morning,
I'm designing a new product based on the nRF52840 device (s140) and power consumption is one of the key parameters for my project.
The equipment (peripheral...
I'm debugging some corner-cases with my own DFU process and Bootloader. I believe I hit a race condition in which sd_mbr_command() was called before the source of the new...
I am trying to make a service discovery on a peripheral device using a nrf52-DK (pca10040). I built my project around the multi-discovery example from SDK 15.3.
When performing...
Hey all,
I'm trying to replace the nrf_cli_uart transport layer with the CDC ACM equivalent (nrf_cli_cdc_acm), since I have an nrf52840 dongle and can't use the uart libraries...
OS : Ubuntu
SDK: 15.3.0_59ac345
Base example : peripheral/saadc
HW : nRF52832 DK PCA10040 1.2.1 2017.49 682663245
Hello, i would like to make sure the ADC acquisition...
Hello,
I am using nRF52832, SDK_15.3.0, S132 SoftDevice and Segger for flashing the image. I am using ‘ble_app_blinky’.
I want to check for debounce of a level on...
Dear support,
What are the absolute minimum decoupling cap sizes running the nrf52810? The application is extremely power sensitive and it is not desirable to have any...
