Hi all,
I am using ble open mesh with pca10028 boards ble mesh is working fine.
I am developing a application that has to blink led in mesh( without any delay between...
I'm still on stack 8.0.0 so it might have been fixed since. I have noticed that if the other side de-asserts CTS the Nordic code will leave the TX asserted in a Break condition...
Hello,
I'd like to ask what is the data rate when using BLE OpenMesh network and how much it depends on network architecture.
I'm considering using it in a network consisting...
Hello Nordic Community,
I need to know how to import my PCB design from Eagle to CST Studio to simulate it and I need to know if the simulation step will be useful to enhance...
Hi.
I'm trying to get Apple notifications to nrf52. And specifically to listen both regular ANS (for android) and ANCS (for iOS) events depending what sort of phone is...
I am trying to find out the part number of the antenna (I assume it is a PCB antenna) used in the nRF51 DK ( www.nordicsemi.com/.../nRF51-DK) . I found a lot of similar questions...
Hi.
I am using the NRF52 Development board, on Keil uVision, to implement a C program that uses Dynamic Structs. The Structs re-size themselves ( by increasing their capacity...
Hi dear team,
I am using the nRF5840 Dongle and pc-ble-driver-py for development, but I encountered a lot of issue while debugging, I thought I used wrong parameter or other...
We have worked through getting AWS MQTT working and have the FOTA job file loading properly. When the HTTP request is made the file begins downloading but fails to download...
Hello, How do I program the NRF52840 module to read and write data with a single UUID, because the mobile application I used earlier was working with the data read and write...
Hi Nordic
I am trying to run the AWS BLE FreeRTOS demo found at:
https://docs.aws.amazon.com/freertos/latest/userguide/ble-demo.html#ble-demo-mqtt
I am using an...
Hi,
I am developing a product with battery power. To preserve the battery life, this product needs to work in low power mode.
My Environment is a nRF52832, SDK15.2 & custom...
Here S332 -ble_ant_app_hrm file is modified using supported board pca10040 (nrf52832).
There is in pca10040.h file,RX pin number & TX pin number predefined.
And we use...
Hello,
until now, I was using nrfjprog to flash devices. Command I used:
Now I have changed the platform, and am forced to use ARM processor. I found out there is a...
Hey
I want to use pin 57 (SIO_10)and pin59 (SIO_09) as output pin but they are configured as NFC pin by default. How to change the configuration to SIO without using the...
I am trying to do the same thing that others have tried in the past, and that is to modify the ble_app_uart_c example to connect to our custom peripheral device.
I have...
Trying to get this working
err_code = nrf_ble_scan_filter_set(&m_scan, SCAN_ADDR_FILTER, AddressTable[Index].peer_addr.addr);
The error code returned is 7. Not sure what...
Hi,
1. Is there an example to show how to send a door lock cluster events command?
2. How to check door lock cluster events by CLI(@coordinator)?
Best Regards
S...
